MBM350MF

Ford Falcon BA-FG XR8/6T/GT Sedan 2 1/2in Dual Rear Muffler 3in Stainless Tips

Ford Falcon BA-FG XR8/6T/GT Sedan 2 1/2in Dual Rear Muffler 3in Stainless Tips (MBM350MF) Fits a wide range.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $648.42 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon BA-FG XR8/6T/GT Sedan 2 1/2in Dual Rear Muffler 3in Stainless Tips product image

Part specs

SKU
MBM350MF
Supplier
MPI Automotive
Category
Mufflers and resonators
Stock status
In stock at supplier

Finished in 304 stainless with 3in tips on show: the MPI Automotive MBM350MF is a 2in dual rear muffler listed to fit the Ford Falcon BA–FG XR8 and GT sedan. The stainless construction is the headline here — it's the corrosion-resistant rear section, capped with polished tips that sit out under the rear bar.

Why 304 stainless for the rear muffler?

The rear muffler and tips live in the wettest, dirtiest part of the car, behind the rear wheels, so material matters most here. 304 stainless resists the rust that eats aluminised rear sections, holding its finish and its integrity far longer. On a BA–FG XR8 or GT sedan, that means the visible tips keep looking right and the muffler outlasts a budget replacement.

What's the 3in tip about?

This is the rear-most silencing stage, the part you see and hear. The 3in stainless tips give the Falcon's tail a finished look under the rear bar, while the dual-rear layout matches the XR8/GT's twin routing. It's a presentation and durability upgrade for the back of the car rather than a centre or front change.

Will it suit my Falcon XR8 or GT?

It's listed to fit the BA through FG Falcon XR8 and GT sedan. That's a long run of the same body family, so confirm your exact series and rear-end with the workshop before ordering — feed data spans several years and we'd rather verify the routing than assume it.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits stainless rear sections like this in-house across the Illawarra. We check the dual hangers and tip alignment so the 3in tips sit square in the rear bar, confirm the fit against your sedan, and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What is the MBM350MF made from?
It's built in 304 stainless steel, which resists the corrosion that affects aluminised rear sections, and it's capped with 3in stainless tips.
Does it fit both XR8 and GT Falcons?
It's listed to fit the BA–FG Falcon XR8 and GT sedan. Confirm your exact series with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.