MKFD0044

Ford Falcon AU 6 Cylinder Wagon Full System Muffler/Tailpipe

MPI Automotive Ford Falcon AU 6 Cylinder Wagon Full System Muffler/Tailpipe.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2111.59 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon AU 6 Cylinder Wagon Full System Muffler/Tailpipe product image

Part specs

SKU
MKFD0044
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0044 is a full-length exhaust system listed to fit the AU Falcon six-cylinder wagon — the complete run, not just the rear. It finishes through a rear muffler and tailpipe and is built around the long wagon body.

What does a full system cover that a cat-back doesn't?

A full system replaces a longer span of the exhaust in one matched run rather than only the section behind the catalytic converter, which is why it sits well above the cat-back in price. For the AU six-cylinder wagon, that means a coordinated line front to back, finishing through a single rear muffler and tailpipe. The supplier hasn't published a single bore figure for this listing, so we confirm pipe sizing at fitting.

Why the wagon body?

The AU wagon's longer rear floor and load-area layout route the exhaust differently to the sedan and ute. The MKFD0044 is cut to suit the wagon's bends, hangers and tailpipe exit, which is why it carries its own part number. A six-cylinder wagon packages differently again to a V8, and this part is built for that combination.

Will it suit my AU wagon?

It's listed to fit the Ford Falcon AU six-cylinder wagon. AU wagons came in a few specs over the run, so send your exact build to the workshop and we'll confirm the routing and hanger points before ordering. We treat the listing as a guide and verify the car on the hoist first.

What does fitting a full system involve in Illawarra?

A full system is a bigger job than a rear-only swap, and Oak Flats Muffler Men fits it in-house. We mount the complete run on the hoist, set the muffler and tailpipe for clearance against the wagon's rear floor, and check the whole line hangs clean before sign-off. The MKFD0044 is held at its listed RRP as a special-order item; we'll confirm lead time when you book.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this the whole exhaust or just the back?
It's a full-length system finishing through a rear muffler and tailpipe — a longer span than a cat-back. It's listed for the AU six-cylinder wagon.
Will it fit a sedan or ute?
No — it's cut for the wagon body. The sedan and ute route the exhaust differently and use their own part numbers.
What pipe diameter is it?
The supplier hasn't published a bore figure for this listing. We confirm sizing against your wagon when it's fitted.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.