MKFD0046

Ford Falcon AU 6 Cylinder Wagon Catback Muffler/Tailpipe

Ford Falcon AU 6 Cylinder Wagon Catback Muffler/Tailpipe (MKFD0046) Fits FORD. Fast shipping, warranty included.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $700.30 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon AU 6 Cylinder Wagon Catback Muffler/Tailpipe product image

Part specs

SKU
MKFD0046
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Cut for the long wagon body, the MPI Automotive MKFD0046 is a cat-back listed to fit the AU Falcon six-cylinder wagon. It runs a rear muffler out to a tailpipe, replacing the section behind the catalytic converter.

Why a wagon-specific cat-back?

The AU wagon carries a longer rear floor and a different over-axle and load-area layout to the sedan and ute, so the rear exhaust has to be bent and hung to suit that body. The MKFD0046 is built around the wagon's routing, finishing through a rear muffler and tailpipe, which is why it carries its own part number. The supplier hasn't published a single bore figure for this listing, so we confirm pipe sizing at fitting.

What's a cat-back and what does it leave standard?

A cat-back replaces the run behind the catalytic converter — the muffler and tailpipe — and leaves the cat and engine-side pipework in place. The factory emissions hardware stays put, and the rear muffler keeps the six-cylinder note measured. It's the straightforward path for a tidy rear-section upgrade on a daily-driven wagon.

Will it suit my AU wagon?

It's listed to fit the Ford Falcon AU six-cylinder wagon. AU wagons ran in a few specs over the production run, so send your exact build to the workshop and we'll confirm the hanger points and tailpipe exit before ordering. Feed data can be imperfect, so we use the listing as a guide and verify the car on the hoist.

What does fitting involve in Illawarra?

Oak Flats Muffler Men supplies and fits this MPI Automotive cat-back in-house. We mount the rear section on the hoist, set the muffler and tailpipe for clearance against the wagon's longer rear floor, and check nothing fouls before sign-off. The MKFD0046 is held at its listed RRP as a special-order item; we'll confirm lead time when you book.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the MKFD0046 fit an AU sedan or ute?
No — it's cut for the wagon body, which routes the rear exhaust differently. The sedan and ute use their own part numbers.
Is it a full exhaust?
No — it's a cat-back, replacing the muffler and tailpipe behind the catalytic converter. The cat and front pipework stay factory.
What pipe diameter is it?
The supplier hasn't published a bore figure for this listing. We confirm pipe sizing against your wagon when it's fitted.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.