MKFD0123

Ford BF GT V8 Sedan 2.5in L & R CatBack Hotdog/Muffler

MPI Automotive Ford BF GT V8 Sedan 2.5in L & R CatBack Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1965.79 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford BF GT V8 Sedan 2.5in L & R CatBack Hotdog/Muffler product image

Part specs

SKU
MKFD0123
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Listed for the BF GT V8 sedan, the MPI Automotive MKFD0123 runs left-and-right exits down a 2.5in cat-back, with a hotdog resonator ahead of a muffler. The L-and-R routing splits a pipe each side. It fits the Ford BF GT V8.

What does the L-and-R layout give the GT?

L-and-R runs a separate pipe down each side of the sedan, exiting left and right rather than through a single path — the twin-exit routing the workshop sets up for the BF GT. Combined with a hotdog resonator ahead of the rear muffler, the MKFD0123 keeps the V8 present and clean across its 2.5in run.

Hotdog plus muffler — the character

The hotdog is a straight-through resonator that tunes out cruise drone; the muffler behind it does the broad absorption. Together they give the GT V8 a present but controlled note, not the loudest layout. At 2.5in it's sized for the standard Falcon eight.

Which Falcon is it for?

It's listed for the BF GT V8 sedan, so the left-and-right routing is shaped for that car. As a cat-back it replaces the pipework from the catalytic converter rearward and leaves the factory emissions hardware in front in place.

Fitting it at our Illawarra workshop

Oak Flats Muffler Men supplies and fits the MKFD0123 in-house. We set the left and right exits, confirm clearance, match the listed BF GT fitment and book the bay. As an MPI Automotive system it's a special-order item we bring in to suit your sedan, so the fitment is confirmed before we place the order rather than after. Supplier RRP is AUD 1,965.79.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What does L-and-R mean on this kit?
It runs a separate pipe down each side of the sedan, exiting left and right rather than through one path. We set the twin exits during fitting.
Is this the GT-specific listing?
Yes — it's listed for the BF GT V8 sedan. Confirm your exact build with the workshop before ordering.
Does it keep the cat?
Yes — it's a cat-back, so it starts behind the catalytic converter and leaves the factory emissions hardware in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.