MKFD0135

Ford Falcon BA BF 6 Cylinder XR6 Ute CatBack Hotdog/Muffler

Ford Falcon BA BF 6 Cylinder XR6 Ute CatBack Hotdog/Muffler (SKU: MKFD0135) Engineered. Quality guaranteed.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $878.02 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon BA BF 6 Cylinder XR6 Ute CatBack Hotdog/Muffler product image

Part specs

SKU
MKFD0135
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Listed for the BA/BF XR6 ute, the MPI Automotive MKFD0135 runs a hotdog resonator ahead of a rear muffler — a tuning-led cat-back for the six-cylinder XR6 in ute form. It's listed to fit the Ford Falcon BA/BF.

What suits the XR6 ute here?

This is the cat-back for the six-cylinder XR6 ute. A hotdog resonator ahead of the rear muffler cleans up the inline-six's cruise drone while the muffler handles broad absorption — a present, road-friendly note for the ute rather than the loudest layout. The routing is shaped for the ute tray and chassis.

What's a hotdog and where does it sit?

A hotdog is a compact straight-through resonator: gas passes through a perforated core, so it targets a single resonant frequency rather than broadly muffling. In the MKFD0135 it leads the cat-back, with the rear muffler behind doing the heavier quietening.

Is the bore published?

No — MPI hasn't listed a diameter for this part, so we don't quote one. The workshop confirms the actual pipe size against your XR6 ute when we check the fitment rather than assuming a figure.

Fitting it in the Illawarra

Oak Flats Muffler Men supplies and fits the MKFD0135 in-house. We match the listed XR6 ute fitment, check tray and chassis clearance and book the bay. As an MPI Automotive part it's brought in to order to suit your ute, so we confirm the fitment before the part is ordered rather than after, and check the existing hangers and exit position while it's on the hoist. Supplier RRP is AUD 878.02.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this for the XR6 ute specifically?
Yes — it's listed for the BA/BF six-cylinder XR6 ute. Confirm your build with the workshop before ordering.
What pipe size is it?
MPI hasn't published a diameter for this listing, so we confirm the bore against your car rather than quote a figure that isn't in the data.
Does it keep the cat?
Yes — it's a cat-back, so it starts behind the catalytic converter and leaves the factory emissions hardware in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.