MKFD0163

Ford BA BF V8 RTV Ute 2.5in CatBack Muffler

Ford BA BF V8 RTV Ute 2.5in CatBack Muffler/Muffler (MKFD0163) Fits FORD. Fast shipping, warranty included.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1690.05 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford BA BF V8 RTV Ute 2.5in CatBack Muffler/Muffler product image

Part specs

SKU
MKFD0163
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Listed for the BA/BF V8 RTV ute, the MPI Automotive MKFD0163 is a 2.5in cat-back with twin chambered mufflers — the routing and clearance worked around the tray and chassis of the ute body. It fits the Ford BA/BF V8.

Why the RTV ute matters for routing

A ute runs its rear section under a tray and around a ladder chassis, not a sedan boot, so the MKFD0163 is shaped for that body. It's listed specifically for the BA/BF V8 RTV ute — the routing, hanger points and rear exit are set for the ute, which is why the right body listing matters when you order.

What does the twin-muffler 2.5in cat-back give?

Two chambered mufflers across the 2.5in run absorb sound broadly rather than tuning one frequency, so the V8 note stays controlled. At 2.5in it's sized for the standard Falcon eight. Cat-back means it replaces the pipework from the catalytic converter rearward and leaves the emissions hardware ahead of it alone.

Is it road legal?

It's a cat-back, so the factory catalytic converter and the emissions equipment in front of it stay in place — this is a rear-section change, not a cat delete. Confirm any state requirements with the workshop before fitting.

Fitting the ute in the Illawarra

Oak Flats Muffler Men fits ute cat-backs like this in-house. We confirm the RTV ute fitment, check tray and chassis clearance over the run, and book the bay. Supplier RRP is AUD 1,690.05.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this the ute version specifically?
Yes — it's listed for the BA/BF V8 RTV ute, with routing and clearance set for the ute body. Confirm your build with the workshop before ordering.
Does it delete the catalytic converter?
No. It's a cat-back, so it starts behind the cat and leaves the factory emissions hardware in place.
What bore is it?
It's a 2.5in cat-back, sized for the standard BA/BF V8.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.