MKFD0167

Ford BA BF V8 1 ton Ute 2.5in CatBack Hotdog/Muffler

MPI Automotive Ford BA BF V8 1 ton Ute 2.5in CatBack Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1631.53 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford BA BF V8 1 ton Ute 2.5in CatBack Hotdog/Muffler product image

Part specs

SKU
MKFD0167
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0167 is a 2.5in cat-back for the Ford BA/BF V8 one-tonne ute silenced with a hotdog. The hotdog is the middle ground of the BA/BF ute cat-backs — a straight-through resonator that trims drone while keeping the system free-flowing.

Why the hotdog on this cat-back?

The MKFD0167 uses a hotdog: a slim, perforated, straight-through resonator that tunes out drone frequencies without choking flow. On the BA/BF V8 one-tonne ute it sits between an open without-muffler build and a fully chambered one — it keeps the gas path largely open and the note firm while taking the edge off the worst resonance. It's the pick for a harder note that's still liveable. We can't quote a sound level; hearing a comparable fit is the honest measure.

What's the 2.5in cat-back layout?

It runs from the catalytic converter back on a 2.5in bore, carrying the gas along the one-tonne ute's underbody to the rear. The 2.5in sizing matches the V8 in standard or lightly modified tune, with the hotdog as the single silencing stage. This resets the rear section in one piece rather than swapping individual boxes.

Will it suit my BA/BF one-tonne ute?

It's listed to fit the Ford BA/BF V8 one-tonne ute. The one-tonner's chassis and rear layout differ from the standard ute and sedan, which is why this cat-back is shaped for it. Confirm your exact build with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKFD0167 in-house across the Illawarra. We hang the pipe and hotdog to the factory mounts, check clearance along the chassis on the one-tonner, and join it square. Bring the ute in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What silencer does the MKFD0167 use?
A hotdog — a compact straight-through resonator that cuts drone while keeping the gas path open, on the 2.5in cat-back for the BA/BF V8 one-tonne ute.
What bore is it?
It's 2.5in — suited to the V8 in standard or lightly modified tune.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.