MKFD0186

Ford FG V8 Sedan 2.5in L & R CatBack Muffler

Ford FG V8 Sedan 2.5in L & R CatBack Muffler/Muffler (MKFD0186) Fits FORD. Fast shipping, warranty included.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2138.94 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford FG V8 Sedan 2.5in L & R CatBack Muffler/Muffler product image

Part specs

SKU
MKFD0186
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0186 is a 2.5in left-and-right cat-back for the Ford FG V8 sedan, silenced with mufflers. The chambered muffler build is the point here — it's the more subdued of the FG sedan cat-backs, leaning on absorption to keep the note in check.

Why the muffler build?

The MKFD0186 uses mufflers rather than a straight-through resonator. A muffler quietens by absorbing and reflecting sound inside a baffled body, so on the FG V8 sedan this is the more measured option — it keeps overall volume in check rather than leaving the system fully open. It's the pick for owners who want the V8 freshened at the back without lifting the note. We can't put a number on the sound; the honest test is to hear a comparable fit.

What's the 2.5in L and R cat-back layout?

It runs from the catalytic converter back as a left-and-right pair on a 2.5in bore. The 2.5in sizing matches the V8 in standard or lightly modified tune, and the dual routing carries each bank along the FG sedan's floor to the rear. This resets the whole back section in one piece rather than swapping a single box.

Will it suit my FG V8 sedan?

It's listed to fit the Ford FG V8 sedan. The sedan's rear floor and hanger layout differ from the ute, which is why the cat-back is built specifically for the sedan body. Confirm your exact build with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKFD0186 in-house across the Illawarra. We hang both sides to the factory mounts, check clearance to the floor and tunnel on the FG sedan, and set the exits square at the rear. Bring the car in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MKFD0186 the quieter option?
It uses chambered mufflers, which keep volume more in check than a straight-through design. We can't give a decibel figure — judge it by hearing a comparable fit.
What bore is it?
It's 2.5in — suited to the V8 in standard or lightly modified tune, run as an L and R pair.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.