MKFD0187

Ford FG V8 Sedan 2.5in L & R CatBack Hotdog/Muffler

Ford FG V8 Sedan 2.5in L & R CatBack Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2050.37 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford FG V8 Sedan 2.5in L & R CatBack Hotdog/Muffler product image

Part specs

SKU
MKFD0187
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0187 is a 2.5in left-and-right cat-back for the Ford FG V8 sedan, silenced with a hotdog. The hotdog is the angle here — a straight-through resonator that keeps the dual system free-flowing and the note harder-edged.

What does the hotdog give this cat-back?

The MKFD0187 runs a hotdog: a compact, perforated, straight-through resonator that tunes out drone frequencies while leaving the gas path open. On the FG V8 sedan that keeps the system breathing and the note firmer than a chambered muffler would, so it's the choice for owners who want the V8 less restrained at the back. It targets resonance rather than smothering volume. We can't quote a sound figure; the honest test is to hear a comparable fit.

What's the 2.5in L and R layout?

It's a cat-back from the catalytic converter rearward, built as a left-and-right pair on a 2.5in bore. The 2.5in sizing suits the V8 in standard or lightly modified tune, and the dual routing carries each bank back along the FG sedan's floor to the rear. This resets the whole back section rather than a single box.

Will it suit my FG V8 sedan?

It's listed to fit the Ford FG V8 sedan. The sedan's rear floor and hanger spacing differ from the ute, which is why the cat-back is shaped for the sedan body. Confirm your exact build with the workshop before ordering.

How do we fit it in Illawarra?

Oak Flats Muffler Men supplies and fits the MKFD0187 in-house across the Illawarra. We hang both sides to the factory mounts, check clearance to the floor and tunnel on the FG sedan, and set the exits square at the rear. Bring the car in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MKFD0187 a louder build?
It uses a straight-through hotdog rather than a chambered muffler, the freer-flowing and harder-edged design. We can't give a decibel figure — judge it by hearing a comparable fit.
What bore is it?
It's 2.5in — suited to the V8 in standard or lightly modified tune, run as an L and R pair.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.