MKFD0203

Ford FG GT 5.0 V8 SDN 2.5in L & R Catback Hotdog/Muffler

MPI Automotive Ford FG GT 5.0 V8 SDN 2.5in L & R Catback Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1966.31 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford FG GT 5.0 V8 SDN 2.5in L & R Catback Hotdog/Muffler product image

Part specs

SKU
MKFD0203
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0203 is a 2.5in left-and-right cat-back for the Ford FG GT V8 sedan, built around a hotdog silencer. The hotdog is the defining choice — a straight-through resonator that keeps the dual GT system free-flowing while trimming drone.

Why a hotdog for the FG GT?

The MKFD0203 uses a hotdog rather than a chambered muffler: a slim, perforated, straight-through resonator that targets drone frequencies while leaving the gas path largely open. On the FG GT V8 sedan that keeps the note harder-edged and the dual system breathing, which suits the GT character. It tunes resonance rather than blanketing volume. We can't put a number on the sound; hearing a comparable fit is the honest measure.

What's the 2.5in L and R cat-back layout?

It runs from the catalytic converter back as a left-and-right pair on a 2.5in bore. The 2.5in sizing matches the V8 in standard or lightly modified tune, and the dual routing carries each bank along the FG sedan's underbody to the rear. This resets the whole back half of the GT's exhaust rather than swapping a single box.

Will it suit my FG GT sedan?

It's listed to fit the Ford FG GT V8 sedan. The sedan's rear floor and hanger layout differ from the ute, and the GT's rear bumper exit shapes how the tailpipes present, which is why this cat-back is built specifically for it. Confirm your exact build with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKFD0203 in-house across the Illawarra. We hang both sides to the factory mounts, check clearance to the floor and tunnel on the FG sedan, and set the exits square at the rear. Bring the GT in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MKFD0203 a quiet or loud build?
It uses a straight-through hotdog rather than a chambered muffler, which is the freer-flowing, harder-edged design. We can't give a decibel figure — judge it by hearing a comparable fit.
What bore is it?
It's 2.5in — suited to the V8 in standard or lightly modified tune, run as an L and R pair.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.