MKFD0215

Ford FG V8 Ute 2.5in Dual CatBack Hotdog/Muffler

MPI Automotive Ford FG V8 Ute 2.5in Dual CatBack Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1559.47 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford FG V8 Ute 2.5in Dual CatBack Hotdog/Muffler product image

Part specs

SKU
MKFD0215
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0215 is a 2.5in dual cat-back for the Ford FG V8 ute built around a hotdog silencer. The hotdog is the defining choice here — a compact straight-through resonator that controls drone while keeping the dual system free-flowing.

Why a hotdog on this cat-back?

The MKFD0215 uses a hotdog — a slim, perforated, straight-through resonator — rather than a heavily chambered muffler. On the FG V8 ute that means the dual system stays freer-flowing and the note harder-edged, with the hotdog tuning out the worst of the cabin drone rather than blanketing volume. It's the pick when you want the back of the V8 to breathe and keep some character. We can't quote a sound level; hearing a comparable fit is the honest measure.

What's the 2.5in dual cat-back layout?

It runs from the catalytic converter back as a dual 2.5in system, carrying each bank along the FG ute's underbody to the rear. The 2.5in bore matches the V8 in standard or lightly modified tune, and the twin routing is the conventional layout for a V8 ute back half. This resets the whole rear section rather than swapping a single box.

Will it suit my FG V8 ute?

It's listed to fit the Ford FG V8 ute. The ute's rear floor and tray-side clearances differ from the sedan, which is why the dual cat-back is shaped for the ute body. Confirm your exact build with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKFD0215 in-house across the Illawarra. We hang both pipes to the factory mounts, check clearance under the tray and along the chassis on the FG ute, and join each side square. Bring the ute in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MKFD0215 louder than a muffler version?
It uses a straight-through hotdog rather than a chambered muffler, which is the freer-flowing, harder-edged design. We can't give a decibel figure — judge it by hearing a comparable fit.
What does the cat-back cover?
It's a dual 2.5in cat-back, replacing the system from the catalytic converter rearward on the FG V8 ute.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.