MKFD0225

Ford FG V8 Ute 2.5in L & R CatBack Muffler/Hotdog

Ford FG V8 Ute 2.5in L & R CatBack Muffler/Hotdog (MKFD0225) Fits FORD. Fast shipping, warranty included.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2178.96 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford FG V8 Ute 2.5in L & R CatBack Muffler/Hotdog product image

Part specs

SKU
MKFD0225
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0225 is a 2.5in left-and-right cat-back for the Ford FG V8 ute that pairs a muffler with a hotdog. It's the mixed-silencer build — a chambered muffler on one side of the system working with a straight-through hotdog — across a dual 2.5in layout.

What does the muffler-and-hotdog combination do?

This MKFD0225 runs both silencer types: a muffler, which quietens by absorbing and reflecting sound inside a baffled body, alongside a hotdog, a compact straight-through resonator that targets drone while keeping flow straight. Combining the two on the FG ute gives a measured note — the muffler tempers overall volume while the hotdog cuts the resonant frequencies — without leaning fully on either approach. We can't put a number on the result; the honest test is to hear a comparable fit.

What's the 2.5in L and R layout?

It's a cat-back from the catalytic converter back, built as a left-and-right pair on a 2.5in bore. The 2.5in sizing suits the V8 in standard or lightly modified tune, and the dual routing carries each side back along the FG ute's underbody to the rear. That makes this an end-of-system swap that resets the back half of the exhaust rather than a single-box change.

Will it suit my FG V8 ute?

It's listed to fit the Ford FG V8 ute. The ute body's rear floor, tray-side clearance and hanger layout differ from the sedan, which is why the cat-back is shaped specifically for it. Confirm your exact build with the workshop before ordering.

How do we fit it in Illawarra?

Oak Flats Muffler Men supplies and fits the MKFD0225 in-house across the Illawarra. We hang both sides to the factory mounts, check clearance under the tray and along the chassis on the FG ute, and join each pipe square. Bring the ute in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What silencers does the MKFD0225 use?
It pairs a muffler with a hotdog across the 2.5in L and R cat-back for the FG V8 ute, blending chambered quietening with straight-through drone control.
What bore is it?
It's 2.5in — suited to the V8 in standard or lightly modified tune.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.