MKFD0256T

Ford PX2 & PX3 Ranger 3in Turbo Back Without Cat & With Hotdog, Twin Tip Side Exit

Ford PX2 & PX3 Ranger 3in Turbo Back Without Cat & With Hotdog, Twin Tip Side Exit (MKFD0256T) Fits FORD.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1661.92 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PX2 & PX3 Ranger 3in Turbo Back Without Cat & With Hotdog, Twin Tip Side Exit product image

Part specs

SKU
MKFD0256T
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0256T is a 3in turbo-back listed to fit the PX2 and PX3 Ford Ranger, finished with a twin-tip side exit, run without the catalytic converter but with a hotdog resonator. The side-exit-with-hotdog combination is what sets it apart from the bare cat-delete builds.

Why the side exit plus a hotdog?

The MKFD0256T pairs two distinguishing features: a twin-tip side exit and a hotdog resonator. The side exit turns the tailpipes out ahead of the rear wheel, and the hotdog — a compact straight-through resonator — takes a little harshness out of the note rather than leaving it completely bare. It is the cat-delete build with a touch of mid-system tuning.

What does a turbo-back without cat involve?

At 3in this turbo-back replaces the exhaust from the turbo outlet rearward on the PX2/PX3 Ranger. This version deletes the catalytic converter, which makes it the off-road specification. Because this build deletes the catalytic converter on a road-relevant system, it is not ADR 79/04 compliant for road registration in NSW and is intended for off-road or competition use only.

Will it suit my Ranger?

The MKFD0256T is listed to fit the PX2 and PX3 Ford Ranger. Build, cab and trim vary, so confirm your exact ute with the workshop — and that the side-exit routing clears your setup — before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits turbo-back systems like this across the Illawarra. We check the side-exit outlet clearance, hang the run with the hotdog in place and confirm the off-road intent with you before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MKFD0256T road legal?
No. It deletes the catalytic converter, so it is not ADR 79/04 compliant for road registration in NSW and is for off-road or competition use only.
Does it have any silencing?
It runs a hotdog resonator, a compact straight-through unit that softens the note slightly. There is no full muffler in this build.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.