MKFD0280

Ford Next Gen T6.2 Ranger 4cyl 2.0L Bi-Turbo 3in DPF Back Without Centre Muffler

Ford Next Gen T6.2 Ranger 4cyl 2.0L Bi-Turbo 3in DPF Back Without Centre Muffler (SKU: MKFD0280) Engineered

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1022.49 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Next Gen T6.2 Ranger 4cyl 2.0L Bi-Turbo 3in DPF Back Without Centre Muffler product image

Part specs

SKU
MKFD0280
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

A 3in dpf-back for the 2.0L bi-turbo, the MPI Automotive MKFD0280 is listed to fit the Next-Gen T6.2 Ford Ranger 4cyl and runs without the centre muffler. The 3in bore is matched to the four-cylinder bi-turbo rather than the larger V6.

A 3in dpf-back matched to the 2.0L bi-turbo

The MKFD0280 leads on its sizing: 3in pipework chosen for the 2.0L bi-turbo four-cylinder in the Next-Gen Ranger. A dpf-back starts at the diesel particulate filter outlet and replaces the run rearward, so it is the back-half upgrade that frees the exhaust path without touching the filter or the emissions hardware ahead of it.

What does removing the centre muffler do?

This version deletes the centre muffler, taking out one of the mid-system silencing chambers. The note opens up over the fully muffled layout while the rear section still carries the final quietening. It is a straightforward, rear-exit configuration rather than a side-exit build.

Is it listed for my Ranger?

The MKFD0280 is listed to fit the Next-Gen T6.2 Ford Ranger with the 4cyl 2.0L bi-turbo. Because cab and trim differ across the range, confirm your exact build with the workshop before ordering so the listing is matched to your ute.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits these dpf-back systems in-house across the Illawarra. We align the section to the DPF outlet, set the hangers and check rear clearance against your Ranger before the bay is booked. As a special-order part from MPI Automotive, we confirm availability and the listing match with you before anything is ordered, so the system that arrives is the one cut for your engine and cab.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Which engine is the MKFD0280 for?
It is listed for the Next-Gen Ranger 4cyl 2.0L bi-turbo. Confirm your engine with the workshop before ordering, as the V6 uses different sizing.
Is this the side-exit version?
No. This is the standard rear-exit dpf-back without the centre muffler. There is a separate twin-tip side-exit configuration.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.