MKFD0296

Ford Next Gen T6.2 Ranger V6 4in DPF Back Without Centre Muffler

Ford Next Gen T6.2 Ranger V6 4in DPF Back Without Centre Muffler (MKFD0296) Fits FORD. Fast shipping.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1642.70 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Next Gen T6.2 Ranger V6 4in DPF Back Without Centre Muffler product image

Part specs

SKU
MKFD0296
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive MKFD0296 is a 4in dpf-back exhaust listed to fit the Next-Gen T6.2 Ford Ranger V6, run without the centre muffler. With the V6 ute as its target and a 4in bore through the rear, it is the diesel-V6 sizing rather than the four-cylinder fitment.

A 4in dpf-back sized for the V6 Ranger

What marks the MKFD0296 out is the V6-specific 4in routing. The dpf-back format means it picks up from the diesel particulate filter outlet and replaces the run rearward at 4in, a wider path than the standard tubing on the Next-Gen Ranger. It is built for the six-cylinder diesel, not the smaller engines in the model line.

What does deleting the centre muffler change?

Skipping the centre muffler takes out a mid-system silencing chamber. The result is a more open note than the muffled layout, while the DPF and the factory emissions equipment ahead of the system stay exactly where Ford put them — this is a back-half change, not an emissions delete.

Is it listed for my Ranger?

The MKFD0296 is listed to fit the Next-Gen T6.2 Ford Ranger V6. Because cab, year and trim vary across the range, confirm your exact build with the workshop so we can check the listing before ordering.

How is it fitted in the Illawarra?

Oak Flats Muffler Men fits these dpf-back systems on the hoist at our Illawarra workshop. We line the section up to the DPF outlet, set the hangers and check tailpipe clearance against the rear of your Ranger before signing it off. As a special-order part from MPI Automotive, we confirm availability and the listing match before ordering, so the 4in system that arrives is the one cut for the V6 build you are running.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the MKFD0296 a full exhaust replacement?
No. It is a dpf-back, so it replaces the pipework from the diesel particulate filter outlet rearward. The DPF and everything ahead of it stay in place.
Will it fit the four-cylinder Ranger?
It is listed for the Next-Gen Ranger V6. Confirm your engine and build with the workshop before ordering, since the four-cylinder uses different sizing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.