MKTY0054

Toyota Landcruiser VDJ200 3in Dual With Cat, NO Muffler, 4in Exit

Toyota Landcruiser VDJ200 3in Dual With Cat, NO Muffler, 4in Exit.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3279.64 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Landcruiser VDJ200 3in Dual With Cat, NO Muffler, 4in Exit product image

Part specs

SKU
MKTY0054
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive MKTY0054 is a 3in dual system for the Toyota Landcruiser VDJ200 that keeps the catalytic converter, runs no muffler, and finishes with a 4in exit. The no-muffler layout is what sets it apart — a freer-flowing, harder-noted dual that still retains the factory cat.

What does running no muffler do?

With the muffler left out, the MKTY0054 lets gas flow more freely through the 3in dual to the 4in exit, giving a harder, louder note than a muffler-equipped system. There's no chambered silencer settling the tone at the back, so the character is more direct — the choice for an owner who wants the open note while still keeping the cat in place.

Does it keep the emissions hardware?

Yes — the MKTY0054 is a with-cat system, so the catalytic converter stays where Toyota fitted it on the VDJ200. On a diesel wagon that's the configuration that leaves the factory emissions equipment intact, which is the usual sticking point for road compliance. Confirm the exact build and any state requirements with the workshop before fitting.

What does the 3in dual with 4in exit suit?

Run as a 3in dual, both banks carry their own pipe, finishing through a 4in exit — a larger tailpipe outlet than the bore behind it for a bigger presence at the rear. Without a muffler, the larger exit and freer path push the VDJ200's note toward the harder end while the retained cat keeps the emissions hardware on the car.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKTY0054 across the Illawarra. A 3in dual with a 4in exit and no rear muffler has two sections and a large tip to position under the wagon, so we check clearance, hanger points and exit position on the car. It's listed to fit the VDJ200 — send your build and we'll book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Why does the MKTY0054 have no muffler?
It's the no-muffler version — gas flows more freely through the 3in dual to the 4in exit for a harder, louder note than a muffler-equipped system.
Does it keep the catalytic converter?
Yes — it's a with-cat system, so the factory catalytic converter stays in place.
Will it fit my 200 Series?
It's listed to fit the Toyota Landcruiser VDJ200. Confirm your rear-bar setup and build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.