MKTY0057

Prado KZJ120R 3.0L 1KZ Engine, 3in Turbo Back, Centre & Rear Muffler With Cat

Prado KZJ120R 3.0L 1KZ Engine, 3in Turbo Back, Centre & Rear Muffler With Cat (MKTY0057) Fits TOYOTA.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1980.96 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Prado KZJ120R 3.0L 1KZ Engine, 3in Turbo Back, Centre & Rear Muffler With Cat product image

Part specs

SKU
MKTY0057
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive MKTY0057 is a 3in turbo-back for the Toyota Prado KZJ120R (3.0L 1KZ) that keeps the catalytic converter and runs a centre and rear muffler. Retaining the cat is the defining choice here — it's the with-cat version of the 1KZ Prado turbo-back, leaving the factory emissions hardware in place.

Does it keep the emissions hardware?

Yes — the MKTY0057 is a with-cat system, so the catalytic converter stays where Toyota fitted it on the KZJ120R. On a turbo-diesel that's the configuration that leaves the factory emissions equipment intact, which is the usual sticking point for road compliance. Confirm the exact build and any state requirements with the workshop before fitting.

What does the centre-and-rear muffler layout do?

The MKTY0057 carries a centre muffler and a rear muffler, settling the note in two stages along the system rather than at a single point. On the 1KZ Prado that gives a composed result — twin silencers knocking down resonance mid-system and at the back — paired with the 3in turbo-back bore that suits the turbo-diesel.

Will it suit my KZJ120R Prado?

The MKTY0057 is listed to fit the Toyota Prado KZJ120R with the 3.0L 1KZ engine. Years and series beyond that aren't published by the supplier. As a turbo-back it replaces the system from the turbo outlet back, so confirm your exact build with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKTY0057 across the Illawarra. With a centre and rear muffler there are two silencers to position and align along the Prado's underbody, so we check clearance and hanger points on the car. It's listed to fit the KZJ120R 1KZ — send your build and we'll book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the MKTY0057 keep the catalytic converter?
Yes — it's the with-cat version, so the factory catalytic converter stays in place.
How many mufflers does it have?
Two — a centre muffler and a rear muffler, silencing the system in two stages for a composed note.
Which Prado is it for?
It's listed for the Toyota Prado KZJ120R with the 3.0L 1KZ engine. Confirm your build with the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.