MKTY0102

Toyota Landcruiser VDJ200 DPF 2.5in With Cat, Muffler Rear, Dump Tip

Toyota Landcruiser VDJ200 DPF 2.5in With Cat, Muffler Rear, Dump Tip.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3090.79 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Landcruiser VDJ200 DPF 2.5in With Cat, Muffler Rear, Dump Tip product image

Part specs

SKU
MKTY0102
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive MKTY0102 is a 2.5in DPF-back for the Toyota Landcruiser VDJ200 that keeps the cat, runs a muffler, and finishes with a rear dump tip. The rear-dump exit at the smaller 2.5in bore is what defines it — a simple, single-side outlet rather than a split exit.

What is a rear dump-tip exit?

A rear dump tip exits the gas at a single point toward the back of the VDJ200 rather than splitting it left and right. It's the straightforward outlet arrangement — fewer rear sections to route, and a clean single exit. On the 200 Series that keeps the rear packaging simple while still giving a finished tip.

What does a DPF-back cover and does it keep the cat?

A DPF-back replaces the exhaust from the diesel particulate filter back, so this is the rearward run rather than an engine-back job. The MKTY0102 is a with-cat system, meaning the catalytic converter stays in place and the DPF section is retained — the configuration that leaves the factory emissions hardware on the wagon. Confirm any state requirements with the workshop.

Who does the 2.5in muffler suit?

At 2.5in this is the smaller DPF-back bore MPI lists for the VDJ200, finishing through a chambered muffler. The narrower pipe keeps gas speed up for a near-stock diesel rather than a heavily worked one, and the muffler keeps the note composed — a quiet, tidy upgrade with the single rear dump tip at the back.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the MKTY0102 across the Illawarra. With a single rear dump tip there's one exit to position and align under the wagon, so we check tip clearance and hanger points on the car. It's listed to fit the Landcruiser VDJ200 — send your build and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What exit does the MKTY0102 use?
A single rear dump tip — gas exits at one point toward the back rather than splitting left and right.
Does it keep the cat and DPF?
Yes — it's a with-cat DPF-back, so the catalytic converter stays and the DPF section is retained.
What bore is it?
It's the 2.5in version, the smaller DPF-back bore for the VDJ200, suiting a near-stock diesel.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.