
Mustang FN 5.0L V8 2018-23 3in Full System Centre Hotdogs & Rear
MPI AutomotiveRRP$6985.53Mustang FN 5.0L V8 2018-23 3in Full System Centre Hotdogs & Rear Bi-modal Muffler 4in Quad Tip.
View part
MPI Automotive Ford Falcon BA-BF XR8/6T/GT Sedan 2 1/2in Dual Centre Muffler.
Category: Mufflers and resonators


Sitting in the middle of the system rather than at the tail, the MPI Automotive SSMBM349MF is a dual centre muffler in 2in, listed to fit the Ford Falcon BA and BF XR8, 6T and GT sedan.
A centre muffler is a mid-system silencing stage that works between the front of the exhaust and the rear mufflers. The SSMBM349MF is a chambered unit for a dual layout, so it takes a cut at the note in the middle of the car — softening resonance and shaping the tone before the rear silencers finish the job. At 2in it's matched to the V8 Falcon's dual flow rather than a big-bore build.
It's listed to fit the Ford Falcon BA and BF sedan in XR8, 6T and GT trim. These are the dual-system performance sedans where a centre muffler sits in the run ahead of the rears, so the routing is specific to that body. Confirm your exact model with the workshop before ordering.
A centre muffler is a silencing component, not a catalytic converter or emissions sensor, so it leaves the Falcon's factory cat and hardware as it left the line. It changes how the system sounds in the mid-section, not what it emits. Check state requirements with the workshop.
Oak Flats Muffler Men fits dual centre mufflers in-house across the Illawarra. We confirm where the centre section sits in your Falcon's dual run and that both halves clear the tunnel and floor. Send your XR8 or GT build and we'll confirm fitment and book the bay.
Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.
Oak Flats Muffler Men can check this part against supplier specs, part number, image, RRP and vehicle details for customers around Oak Flats, Shellharbour, Wollongong, Dapto, Albion Park, Kiama and the northern suburbs.
Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.