SSMBM356MFQUAD

Ford Falcon BA XR8/GT & BF, FG XR8 Sedan Dual Outlet Rear Muffler LHS With Twin Tips

Ford Falcon BA XR8/GT & BF, FG XR8 Sedan Dual Outlet Rear Muffler LHS With Twin Tips for selected vehicle applications.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $759.50 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon BA XR8/GT & BF, FG XR8 Sedan Dual Outlet Rear Muffler LHS With Twin Tips product image

Part specs

SKU
SSMBM356MFQUAD
Supplier
MPI Automotive
Category
Mufflers and resonators
Stock status
In stock at supplier

Finished with twin tips on a dual outlet, the MPI Automotive SSMBM356MFQUAD is the left-hand-side rear muffler for a quad-tip Falcon setup, listed to fit the BA XR8 and GT and the BF and FG XR8 sedan.

What makes this the LHS quad muffler?

This is the left-hand side of a paired rear muffler arrangement that gives the Falcon its four-tip look — two tips per side. The SSMBM356MFQUAD is a chambered rear muffler with a dual outlet and twin tips built in, so it both silences and presents the tailpipe finish on the driver's side of a quad exhaust. It's matched to its right-hand partner to complete the rear of the system.

Which Falcons does it suit?

It's listed to fit the Ford Falcon BA XR8 and GT, and the BF and FG XR8 sedan. These are the factory quad-tip performance Falcons, so the muffler is shaped to sit and exit where those cars present their tips. The supplier hasn't published a pipe diameter for this unit, so that's confirmed by the workshop rather than guessed. Verify your exact model before ordering.

Is it road legal?

This is a rear muffler with integrated tips — a silencing and finishing component, not a catalytic converter or emissions part — so the factory cat and sensors stay put. It changes the note and the tailpipe look, not the emissions. Confirm state requirements with the workshop.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits quad-tip rear mufflers in-house across the Illawarra. Tip alignment matters on a four-outlet car, so we set the LHS to sit square in the rear bar alongside the RHS unit. Send your XR8 or GT build and we'll confirm the pairing and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Do I need the matching RHS muffler too?
Yes — this is the left-hand side of a quad-tip pair, so you run it with the matching right-hand muffler to complete the four-tip rear.
What diameter is it?
The supplier hasn't published a pipe diameter for this unit, so the workshop confirms it against your car rather than us guessing a figure.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.