
Mustang FN 5.0L V8 2018-23 3in Full System Centre Hotdogs & Rear
MPI AutomotiveRRP$6985.53Mustang FN 5.0L V8 2018-23 3in Full System Centre Hotdogs & Rear Bi-modal Muffler 4in Quad Tip.
View part
Ford Falcon BA - BF - FG Ute 6 Cylinder 2.5in Centre Muffler (SSMBM361MF) Fits a wide range
Category: Mufflers and resonators


At a 2.5in bore, the MPI Automotive SSMBM361MF sits between the smaller six-cylinder pipe and the big-bore V8 size — a 2.5in centre muffler for the six-cylinder Falcon BA/BF/FG ute. That mid bore is the defining detail on this single-pipe ute section.
A 2.5in bore gives the six-cylinder Falcon ute a touch more flow than the standard pipe while staying matched to the engine's output. The SSMBM361MF takes that 2.5in run through a chambered centre muffler mid-system, doing the bulk of the quietening before the rear. It's the centre can on the single-pipe ute exhaust.
Sitting in the middle of the run, a centre muffler absorbs and reflects sound before it reaches the tailpipe, so it shapes the cruise note more than the full-noise bark. Swapping it lets you renew a rusted or blown factory section, or modestly tidy the sound, without committing to a whole system on the work ute.
It's listed to fit the six-cylinder Ford Falcon BA/BF/FG ute at 2.5in. Because that's a long production span, confirm your exact model and existing pipe size with the workshop before ordering — a 2.5in section belongs on a matching 2.5in run.
Oak Flats Muffler Men fits this centre muffler in-house across the Illawarra. We verify the 2.5in bore, check the pipe and hangers either side, and mate it on the hoist. Send your ute's details and we'll book it in.
Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.
Oak Flats Muffler Men can check this part against supplier specs, part number, image, RRP and vehicle details for customers around Oak Flats, Shellharbour, Wollongong, Dapto, Albion Park, Kiama and the northern suburbs.
Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.