SSMKFD0086

Ford Falcon BA BF 6 Cylinder Sedan Full System Hotdog/Muffler

Ford Falcon BA BF 6 Cylinder Sedan Full System Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3111.05 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon BA BF 6 Cylinder Sedan Full System Hotdog/Muffler product image

Part specs

SKU
SSMKFD0086
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0086 pairs a compact hotdog resonator with a rear muffler in a full exhaust system listed to fit the BA/BF Ford Falcon six-cylinder sedan. That two-stage layout is the defining feature here: a straight-through hotdog up front to take the edge off, then a chambered muffler at the rear to settle the note.

What does a hotdog plus rear muffler give you?

A hotdog is a small straight-through resonator — gas passes through a perforated core wrapped in packing, so it trims a specific frequency without choking flow or adding much length. On its own it leaves a fairly open note; here it works ahead of a conventional rear muffler, which uses internal chambers to drop the overall volume. The combination is aimed at a Falcon owner who wants the system breathing more freely than a tired factory setup while keeping the cabin liveable on the highway.

Is this a full system or just a section?

This is a full system rather than a cat-back or tailpipe-only change, so it covers the run rather than a single component swap. The cat status is not published by MPI Automotive for this listing, so if road compliance matters for your build, that's the first thing to confirm before ordering — the workshop can check what the kit retains.

Will it suit a BA or BF Falcon sedan?

It's listed to fit the Ford Falcon six-cylinder sedan in BA/BF guise. Falcon sedans of this era share much of their underbody, but trim, driveline and prior modifications vary, so treat the listing as a starting point and confirm your exact build with the workshop before committing.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits full Falcon systems like this in-house across the Illawarra. We mount the hotdog and rear muffler on the hoist, check hanger alignment and clearance front to back, and confirm the part suits your car before any cutting. Send your VIN or build details and we'll book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKFD0086 fit my BA Falcon sedan?
It's listed to fit the BA/BF Ford Falcon six-cylinder sedan. Confirm your exact variant and any prior exhaust work with the workshop before ordering.
What's the difference between the hotdog and the muffler in this kit?
The hotdog is a compact straight-through resonator that trims a frequency while staying free-flowing; the rear muffler is chambered and does the bulk of the volume reduction. Together they aim for a freer-breathing system that stays civil in the cabin.
Is it road legal?
The cat status isn't published by the supplier for this listing, so road compliance can't be confirmed from the spec alone. Ask the workshop to verify what the system retains for your car.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.