SSMKFD0151

Ford BA BF V8 Ute 3in Dual CatBack Muffler

Ford BA BF V8 Ute 3in Dual CatBack Muffler/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2608.00 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford BA BF V8 Ute 3in Dual CatBack Muffler/Muffler product image

Part specs

SKU
SSMKFD0151
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Built for the ute body, the MPI Automotive SSMKFD0151 is a 3in dual cat-back for the Ford Falcon BA/BF V8 ute, finishing through a muffler. The ute-specific routing is the point of difference — the system is packaged for the tray floor and rear overhang, not the sedan shape.

Why a ute-specific cat-back?

A BA/BF ute carries a tray and a different rear floorpan to the sedan, so the rear pipework hangs and exits to suit that body. The SSMKFD0151 is built for the ute run, landing its 3in dual pipe and muffler on the ute's mounting points and clearing the tray underside. Getting the routing right for the body is as much a part of this part as the bore is.

What does the 3in dual bore with a muffler give?

A 3in dual run moves plenty of gas, the breathing room a worked or harder-driven V8 tends to want, and finishing through a chambered muffler keeps the note composed rather than open. So the ute gets the bigger pipe doing the flowing with the muffler holding cabin drone and outright volume in check on the road. No sound or power figures are published for it.

Will it suit my BA/BF V8 ute?

It's listed to fit the Ford Falcon BA/BF V8 ute. The record names Ford, the V8 engine and the ute body but not the exact series, so confirm your specific build and tray setup with the workshop before ordering, since the dual routing affects clearance. As a cat-back it leaves the factory cat in place; confirm compliance with us.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits the SSMKFD0151 across the Illawarra. A 3in dual ute system needs its rear muffler and pipework aligned for tray and chassis clearance, so we check hanger positions and tip exit on the vehicle. It's listed to fit the Ford Falcon BA/BF V8 ute; send your build and we'll book it in.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What's distinctive about the SSMKFD0151?
It's the ute-bodied 3in dual cat-back with a muffler, routed for the tray floor and rear overhang rather than the sedan shape.
Is it loud?
It finishes through a chambered muffler, so it's fuller than stock but composed rather than raucous. We can't quote a decibel figure.
Does it fit my Ford ute?
It's listed to fit the Ford Falcon BA/BF V8 ute. Confirm your exact build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.