SSMKFD0164

Ford BA BF V8 RTV Ute 2.5in CatBack Hotdog/Muffler

Ford BA BF V8 RTV Ute 2.5in CatBack Hotdog/Muffler (SKU: SSMKFD0164) Engineered. Quality guaranteed.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2222.64 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford BA BF V8 RTV Ute 2.5in CatBack Hotdog/Muffler product image

Part specs

SKU
SSMKFD0164
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0164 is a 2.5in cat-back built for the Ford BA/BF V8 RTV ute, with a hotdog and a muffler. It's routed for the RTV body specifically — the raised-ride-height ute variant — with a balanced hotdog-and-muffler note.

What's specific about the RTV fitment?

This listing is for the BA/BF V8 RTV ute — the variant the SSMKFD0164 is routed for. Fitting an exhaust to a specific body listing matters for clearance and hanger placement, so the workshop confirms it against your RTV rather than assuming a standard ute layout. Getting the right listing for the body avoids clearance surprises on the hoist.

How does the hotdog-and-muffler path sound?

It runs a straight-through hotdog ahead of a chambered muffler. The hotdog keeps the 2.5in run flowing and trims drone, the muffler absorbs the peak volume — a balanced note on the BA/BF V8. We can't quote a decibel figure, but in type terms it sits between an open and a fully muffled build.

Why 2.5in, and what does cat-back cover?

At 2.5in the bore is matched to the BA/BF V8 as a street cat-back. Cat-back replaces the exhaust from the catalytic converter rearward, keeping the factory cat — so this is the rear-half system, not engine-back, and the hardware ahead of the cat is untouched.

Will it fit my RTV, and who fits it?

It's listed to fit the Ford BA/BF V8 RTV ute; series and year aren't published by the supplier. Oak Flats Muffler Men supplies and fits it across the Illawarra, confirming the RTV routing and hanger points against your vehicle and treating the fitment as listed-to-fit. RRP is $2,222.64; as an MPI Automotive part it can be ordered in.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this specifically for the RTV?
Yes — it's listed to fit the Ford BA/BF V8 RTV ute. We confirm the routing against your RTV before ordering.
Does it keep the cat?
Yes — as a cat-back it leaves the factory catalytic converter in place.
What's in the path?
A straight-through hotdog and a chambered muffler, on a 2.5in cat-back.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.