SSMKFD0191

Ford FG V8 Sedan 3in L & R Catback Hotdog/Muffler

Ford FG V8 Sedan 3in L & R Catback Hotdog/Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3781.29 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford FG V8 Sedan 3in L & R Catback Hotdog/Muffler product image

Part specs

SKU
SSMKFD0191
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0191 brings a hotdog into a handed left-and-right layout: a 3in cat-back for the Ford Falcon FG V8 sedan that pairs a straight-through resonator with a chambered muffler, with the rear running as two separate side-specific pipes. The hotdog keeps it flowing; the handed routing suits the sedan body.

How does the hotdog work in this left-and-right run?

A hotdog is a compact straight-through resonator that flows freely while trimming drone; here it sits ahead of a chambered muffler that settles the volume. Run left-and-right, each handed pipe carries the 3in bore down its own side of the sedan. That combination — a free-flowing resonator and a silencer in a handed dual — is the defining feature of this build, keeping the note managed rather than wide open.

What does the 3in bore suit on the FG V8 sedan?

A 3in bore is matched to the V8 and to owners after freer flow, keeping less back-pressure on a worked engine. Routed as two handed pipes it suits the FG sedan's rear floor and exits. The record gives the 3in bore, the V8 sedan fitment and the hotdog-and-muffler layout — no sound or power figures are published and none are inferred.

What does an L-and-R cat-back cover?

An L-and-R cat-back replaces the exhaust from the catalytic converter rearward as two handed pipes routed for the sedan, leaving the factory cat in place. It's the rear-half upgrade, not engine-back, so the work stays behind the cat and the emissions hardware ahead of it is untouched.

Will it suit my FG sedan, and who fits it?

It's listed to fit the Ford Falcon FG V8 sedan; the series and year aren't published by the supplier. Oak Flats Muffler Men supplies and fits it across the Illawarra, confirming the handed 3in routing and clearances against your build and treating the fitment as listed-to-fit. As an MPI Automotive part it can be ordered in at its listed RRP; confirm compliance with us.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What's distinctive about the SSMKFD0191?
It's the 3in hotdog-and-muffler build in a handed left-and-right layout, so it flows freer than a twin-muffler version while staying managed. It's listed for the FG V8 sedan.
Does it keep the cat?
Yes — as an L-and-R cat-back it leaves the factory catalytic converter in place. Confirm compliance with the workshop.
Which car is it for?
It's listed to fit the Ford Falcon FG V8 sedan. Confirm your exact build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.