SSMKFD0246T

Ford PX Ranger 3.2L With Cat, Hotdog Twin Tip Side Exit

MPI Automotive Ford PX Ranger 3.2L With Cat, Hotdog Twin Tip Side Exit.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2291.30 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PX Ranger 3.2L With Cat, Hotdog Twin Tip Side Exit product image

Part specs

SKU
SSMKFD0246T
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0246T is a with-cat hotdog exhaust for the Ford PX Ranger 3.2L, finishing in a twin-tip side exit. Keeping the catalytic converter is its defining trait — it leaves the factory emissions hardware in place, paired with a compact hotdog resonator.

What does keeping the cat change here?

This SSMKFD0246T retains the catalytic converter rather than deleting it, so the PX Ranger 3.2L keeps the emissions component it left the factory with — the headline difference on a registered diesel ute. Around it the build runs a hotdog, a compact straight-through resonator that trims harshness while staying free-flowing, finishing in a twin-tip side exit. MPI Automotive does not publish a diameter against this listing, so we do not state one.

Is it road legal?

Because this build keeps the catalytic converter, it leaves the emissions hardware in place — the deciding factor for compliance on a registered Ranger. The hotdog is freer-flowing than a muffler, and noise factors into compliance, so confirm the exact build and any state requirements with the workshop before fitting. We do not claim approval sight unseen.

Will it suit my PX Ranger 3.2L?

It is listed to fit the Ford PX Ranger 3.2L. No year range is published against this listing, so we confirm your exact build off the compliance plate before ordering. RRP is $2,291.30.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men fits these PX Ranger systems in our Illawarra bays. We seat the cat, route the hotdog, and set the twin-tip side exit square in the rear quarter, checking clearances along the run before final clamping. Bring the Ranger in and we will confirm the build.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKFD0246T keep the catalytic converter?
Yes. It is the with-cat build, so the factory converter stays in place, run with a hotdog resonator.
Will it fit my PX Ranger 3.2L?
It is listed to fit the Ford PX Ranger 3.2L. Confirm your exact build with the workshop before ordering.
What pipe size is it?
MPI Automotive does not publish a diameter for this listing, so we do not state one. We confirm the spec at the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.