SSMKFD0248

Ford PJ, PK Ranger 3.0L Auto With Cat, Hotdog

MPI Automotive Ford PJ, PK Ranger 3.0L Auto With Cat, Hotdog.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2140.71 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PJ, PK Ranger 3.0L Auto With Cat, Hotdog product image

Part specs

SKU
SSMKFD0248
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0248 is a with-cat hotdog exhaust for the Ford PJ-PK Ranger 3.0L auto. The automatic-specific fitment is its defining trait — it is routed for the auto-transmission cars rather than the manual.

Why does the auto fitment matter?

This SSMKFD0248 is cut for the automatic-transmission PJ-PK Ranger 3.0L, so its routing suits the auto car's gearbox, crossmember and tunnel. That is the distinguishing detail against the otherwise-similar manual version — the driveline underneath sets the pipe path, and the wrong one fouls. It keeps the catalytic converter and runs a hotdog, a compact straight-through resonator. No system type or diameter is published by MPI Automotive for this listing, so we do not state them.

Is it road legal?

Because this build keeps the catalytic converter, it leaves the emissions hardware in place — the deciding factor on a registered Ranger. Confirm the exact build and any state requirements with the workshop before fitting; configuration and vehicle history both matter, and we do not claim approval on a vehicle we have not seen.

Will it suit my PJ-PK Ranger?

It is listed to fit the Ford PJ-PK Ranger 3.0L auto. No year range is published against this listing, so we confirm your exact build off the compliance plate — and check the transmission is automatic, not manual. RRP is $2,140.71.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men fits these PJ-PK Ranger systems in our Illawarra bays. We confirm the auto driveline, route the hotdog, seat the cat and check clearances along the run before final clamping. Bring the Ranger in and we will confirm the build and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the SSMKFD0248 fit my Ranger?
It is listed to fit the Ford PJ-PK Ranger 3.0L auto. Confirm your transmission and exact build with the workshop, as the manual needs a different part.
Does it keep the catalytic converter?
Yes. It is a with-cat build, so the factory converter stays in place, run with a hotdog resonator.
What system type is it?
MPI Automotive does not publish a system type or diameter for this listing, so we do not state them. We confirm the spec at the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.