SSMKFD0252

Ford PX2 & PX3 Ranger 3in DPF Back without muffler

Ford PX2 & PX3 Ranger 3in DPF Back without muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1205.19 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PX2 & PX3 Ranger 3in DPF Back without muffler product image

Part specs

SKU
SSMKFD0252
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0252 is a 3in DPF-back for the Ford PX2 and PX3 Ranger, built without a muffler with a conventional rear exit. The plain rear-exit routing is its defining trait — the straightforward, keener-priced DPF-back without the side-exit tips.

What does this DPF-back cover?

A DPF-back replaces the exhaust from behind the diesel particulate filter rearward, so the SSMKFD0252 swaps the PX2/PX3 Ranger's system from the DPF back while leaving the filter and everything ahead of it factory. At 3in and without a muffler, it runs an open rear section and exits conventionally off the back — no side-exit tips, which keeps it the simplest, leanest-priced DPF-back of the pair.

Will it suit my PX2 or PX3 Ranger?

It is listed to fit the Ford PX2 and PX3 Ranger. MPI Automotive does not publish an engine or year against this listing, so we confirm your exact build off the compliance plate before ordering. RRP is $1,205.19 — the keenest-priced part in the PX DPF-back set.

Is it road legal?

This is a DPF-back, so it sits behind the diesel particulate filter and leaves that hardware in place. The muffler-less layout runs louder, and noise factors into compliance, so confirm the exact build and any state requirements with the workshop before fitting. We do not claim approval on a vehicle we have not seen.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men fits these PX2/PX3 DPF-backs in our Illawarra bays. Without a muffler and with a conventional rear exit the routing is simple, but we still align the run, check clearances along the chassis and confirm the tailpipe sits clear before final clamping. Bring the Ranger in and we will confirm the build.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the SSMKFD0252 fit my Ranger?
It is listed to fit the Ford PX2 and PX3 Ranger. Confirm your exact build with the workshop before ordering.
Does this one have side-exit tips?
No. This is the conventional rear-exit DPF-back, the simpler and keener-priced of the two.
Does it remove the DPF?
No. A DPF-back sits behind the diesel particulate filter and leaves it in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.