SSMKFD0252T

Ford PX2 & PX3 Ranger 3in DPF Back Without Muffler, Twin Tip Side Exit

Ford PX2 & PX3 Ranger 3in DPF Back Without Muffler, Twin Tip Side Exit.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1304.25 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PX2 & PX3 Ranger 3in DPF Back Without Muffler, Twin Tip Side Exit product image

Part specs

SKU
SSMKFD0252T
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0252T is a 3in DPF-back for the Ford PX2 and PX3 Ranger, built without a muffler and finished in a twin-tip side exit. The side-exit twin tips are its defining feature — it is the side-exit version of the muffler-less DPF-back.

What does the twin-tip side exit change?

This SSMKFD0252T finishes in a twin-tip side exit, routing the tailpipe out the rear quarter rather than straight off the back — the visual and packaging trait that sets it apart from the plain rear-exit DPF-back. It is a DPF-back at 3in, replacing the system from behind the diesel particulate filter rearward, and runs without a muffler for an open mid-and-rear section on the PX2/PX3 Ranger.

Will it suit my PX2 or PX3 Ranger?

It is listed to fit the Ford PX2 and PX3 Ranger. MPI Automotive does not publish an engine or year against this listing, so we confirm your exact build off the compliance plate before ordering. RRP is $1,304.25, a small step over the plain rear-exit build for the side-exit tips.

Is it road legal?

This is a DPF-back, so it sits behind the diesel particulate filter and leaves that hardware in place. The muffler-less build is louder, and noise factors into compliance, so confirm the exact build and any state requirements with the workshop before fitting. We do not claim approval on a vehicle we have not inspected.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits these PX2/PX3 DPF-backs in our Illawarra bays. The twin-tip side exit needs the tips set square in the rear quarter and checked for body clearance, then the muffler-less run is aligned and clamped clear of the chassis. Bring the Ranger in and we will confirm the build.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the SSMKFD0252T fit my Ranger?
It is listed to fit the Ford PX2 and PX3 Ranger. Confirm your exact build with the workshop before ordering.
How does it differ from the plain DPF-back?
It exits through twin tips out the side rear quarter rather than straight off the rear.
Does it remove the DPF?
No. A DPF-back sits behind the diesel particulate filter and leaves it in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.