SSMKFD0253T

Ford PX2 & PX3 Ranger 3in Turbo Back With Cat & Muffler, Twin Tip Side Exit

Ford PX2 & PX3 Ranger 3in Turbo Back With Cat & Muffler, Twin Tip Side Exit (SSMKFD0253T) Fits FORD.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2705.27 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PX2 & PX3 Ranger 3in Turbo Back With Cat & Muffler, Twin Tip Side Exit product image

Part specs

SKU
SSMKFD0253T
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0253T is a 3in turbo-back for the Ford PX2 and PX3 Ranger that keeps the catalytic converter and runs a full muffler, finishing in a twin-tip side exit. Cat retained plus a chambered muffler is its defining combination — the most road-friendly and subdued of the turbo-back set.

What does a with-cat, with-muffler turbo-back cover?

A turbo-back replaces the exhaust from the turbo outlet rearward, the longer span past a cat-back. This SSMKFD0253T keeps the catalytic converter and runs a full chambered muffler, so the PX2/PX3 Ranger retains its emissions hardware while the muffler keeps the note the most subdued of the family. At 3in with a twin-tip side exit, it is the civil end of the turbo-back range.

Is it road legal?

Because this build keeps the catalytic converter, it leaves the emissions hardware in place — the deciding factor for compliance on a registered diesel ute. The full muffler also keeps it the quietest of the turbo-backs. Still, confirm the exact build and any state requirements with the workshop before fitting; we do not claim approval sight unseen.

Will it suit my PX2 or PX3 Ranger?

It is listed to fit the Ford PX2 and PX3 Ranger. MPI Automotive does not publish an engine or year against this listing, so we confirm your exact build off the compliance plate before ordering. RRP is $2,705.27 — the dearest of the PX turbo-back set, reflecting the retained cat and full muffler.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men fits these PX2/PX3 turbo-backs in our Illawarra bays. We seat the cat and muffler, set the twin-tip side exit square in the rear quarter, and check clearances along the run before final clamping. Bring the Ranger in and we will confirm the build.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKFD0253T keep the catalytic converter?
Yes — it is the with-cat, with-muffler turbo-back, so the factory converter and a full muffler are both in place.
Is this the quietest of the turbo-backs?
It runs the cat and a full chambered muffler, so it is the most subdued of the PX turbo-back family.
Will it fit my PX3 Ranger?
It is listed to fit the Ford PX2 and PX3 Ranger. Confirm your exact build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.