SSMKFD0254

Ford PX2 & PX3 Ranger 3.2L Turbo Back With Cat, Hotdog

Ford PX2 & PX3 Ranger 3.2L Turbo Back With Cat, Hotdog (SKU: SSMKFD0254) Engineered. Quality guaranteed.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2433.44 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford PX2 & PX3 Ranger 3.2L Turbo Back With Cat, Hotdog product image

Part specs

SKU
SSMKFD0254
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0254 is a turbo-back for the Ford PX2 and PX3 Ranger 3.2L that keeps the catalytic converter and runs a hotdog resonator. Keeping the cat with a compact hotdog is its defining combination — emissions hardware retained, a free-flowing resonator rather than a full muffler.

What does a with-cat hotdog turbo-back cover?

A turbo-back replaces the exhaust from the turbo outlet rearward, taking in the larger-bore section where a 3.2L diesel ute frees up. This SSMKFD0254 keeps the catalytic converter and uses a hotdog — a compact straight-through resonator — instead of a full muffler, so the emissions hardware stays while the rear stays relatively open. The supplier does not publish a pipe diameter against this listing, so we do not state one.

Is it road legal?

Because this build keeps the catalytic converter, it leaves the emissions hardware in place — the deciding factor for a registered 3.2L Ranger. The hotdog is freer-flowing than a muffler, and noise factors into compliance, so confirm the exact build and any state requirements with the workshop before fitting. We do not claim approval on a vehicle we have not seen.

Will it suit my PX2 or PX3 Ranger 3.2L?

It is listed to fit the Ford PX2 and PX3 Ranger 3.2L. No year range is published by MPI Automotive against this listing, so we confirm your exact build off the compliance plate before ordering. RRP is $2,433.44.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits these 3.2L PX2/PX3 turbo-backs in our Illawarra bays. We seat the cat, route the hotdog, and check clearances along the run and at the tailpipe before final clamping. Bring the Ranger in and we will confirm the build and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKFD0254 keep the catalytic converter?
Yes. It is a with-cat turbo-back, so the factory converter stays in place; it runs a hotdog rather than a full muffler.
Will it fit my Ranger 3.2L?
It is listed to fit the Ford PX2 and PX3 Ranger 3.2L. Confirm your exact build with the workshop before ordering.
What pipe size is it?
MPI Automotive does not publish a diameter for this listing, so we do not state one. We confirm the spec at the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.