SSMKFD0275

Ford Next Gen T6.2 Ranger V6 3in DPF Back Without Mufflers

Ford Next Gen T6.2 Ranger V6 3in DPF Back Without Mufflers (SSMKFD0275) Fits FORD. Fast shipping.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1478.02 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Next Gen T6.2 Ranger V6 3in DPF Back Without Mufflers product image

Part specs

SKU
SSMKFD0275
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Running with no mufflers at all is what sets the MPI Automotive SSMKFD0275 apart — a 3in DPF-back listed to fit the Next-Gen T6.2 Ford Ranger V6. It keeps the diesel particulate filter but leaves out the silencing, making it the freest-flowing, loudest of the Ranger DPF-back builds.

What does a no-muffler DPF-back do?

With no mufflers in the run, there's no chambered silencing between the diesel particulate filter and the tailpipe — gas flows through the straightest 3in path this family offers, and the note is at its fullest. On the V6 Ranger that's the most open configuration, suited to an owner who wants maximum flow and the loudest result from a DPF-back. The DPF itself still moderates a diesel's tone, so it isn't a petrol-car bark.

What does a DPF-back cover, and what stays?

A DPF-back replaces the exhaust from the diesel particulate filter rearward, leaving the DPF and the emissions hardware ahead of it in place. At 3in it's stepped up from the factory rear section, sized for the V6. The filter stays where the factory put it — this build changes the rear pipework and removes the mufflers, not the emissions equipment.

Is the DPF retained?

Yes. As a DPF-back, the diesel particulate filter and the hardware in front of it remain fitted, keeping the Ranger closer to factory emissions behaviour than a filter-delete would. Confirm the exact build and any current state requirements with the workshop before fitting, since setups and rules vary.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits DPF-back systems like this in-house across the Illawarra. It's listed to fit the Next-Gen T6.2 Ranger V6; send us your build and we'll confirm clearances and the no-muffler routing before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

How loud is the SSMKFD0275?
It runs with no mufflers, so it's the freest-flowing and loudest of the Ranger DPF-back builds. The DPF still moderates the diesel note. No decibel figure is published.
Does it keep the DPF?
Yes — it's a DPF-back, so the diesel particulate filter and the emissions hardware ahead of it stay in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.