SSMKFD0278

Mustang FN 5.0L V8 2018-23, 3in Dual Catback, Centre Hotdogs & Rear Mufflers 4in Quad

MPI Automotive Mustang FN 5.0L V8 2018-23, 3in Dual Catback, Centre Hotdogs & Rear Mufflers 4in Quad Tips.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3210.37 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Mustang FN 5.0L V8 2018-23, 3in Dual Catback, Centre Hotdogs & Rear Mufflers 4in Quad Tips product image

Part specs

SKU
SSMKFD0278
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

A 3in dual cat-back with twin centre hotdogs is what characterises the MPI Automotive SSMKFD0278, listed to fit the FN Ford Mustang 5.0L V8 from 2018. Paired centre hotdogs feed into rear mufflers and out through 4in quad tips.

What does the dual cat-back layout cover?

A cat-back replaces the system from the catalytic converters rearward, so it's the section behind the emissions hardware. In dual form on the FN Mustang each bank runs its own 3in pipe, sized for the 5.0L Coyote V8. The SSMKFD0278 places a centre hotdog in each run — compact straight-through resonators that flow freely while cutting the harshest edge — then rear mufflers, finishing through 4in quad tips for the FN's four-outlet look.

Why centre hotdogs rather than centre mufflers?

Hotdogs are straight-through, so they flow more openly than a chambered centre muffler while still taming the worst of the note. Pairing them with rear mufflers gives the SSMKFD0278 a fuller V8 voice than an all-muffler build, held in check at the tailpipe. It's the choice for an FN owner who wants the cat-back free-flowing without a fully unmuffled cabin.

Will it suit my FN Mustang?

It's listed to fit the FN Ford Mustang 5.0L V8 from 2018. Confirm your exact build year and rear setup with the workshop before ordering, since the quad-tip fitment depends on the bodywork. We verify the match rather than relying on feed data alone.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits dual cat-back systems like this in-house across the Illawarra. We'll confirm hanger points, the centre hotdog and rear muffler positions and the 4in quad-tip alignment for your FN before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What does the SSMKFD0278 replace?
It's a cat-back, so it replaces the system from the catalytic converters rearward in a 3in dual layout — the emissions hardware ahead of it stays in place.
What are the centre hotdogs?
Compact straight-through resonators that flow freely while cutting the harshest edge off the note, feeding into the rear mufflers.
How is it finished?
Through 4in quad tips, suited to the FN Mustang's four-outlet rear styling.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.