SSMKFD0280T

Ford Next Gen T6.2 Ranger 4cyl 2.0L Bi-Turbo 3in DPF Back, Twin Tip Side Exit Without

Ford Next Gen T6.2 Ranger 4cyl 2.0L Bi-Turbo 3in DPF Back, Twin Tip Side Exit Without Centre Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1537.73 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Next Gen T6.2 Ranger 4cyl 2.0L Bi-Turbo 3in DPF Back, Twin Tip Side Exit Without Centre Muffler product image

Part specs

SKU
SSMKFD0280T
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

The MPI Automotive SSMKFD0280T is a 3in DPF-back for the Next-Gen T6.2 Ford Ranger 4cyl 2.0L bi-turbo, finished with a twin-tip side exit and built without a centre muffler. The deleted centre muffler is its defining trait — a more open mid-section than the muffler-equipped builds.

What does deleting the centre muffler change?

This SSMKFD0280T leaves out the centre muffler, so the 2.0L bi-turbo Ranger's mid-section runs more open than a muffler build would — that is the character this SKU represents. It is a DPF-back, replacing the system from behind the diesel particulate filter, finished in a twin-tip side exit at 3in. The side-exit tips set the visual and the routing apart from a rear-exit layout.

Will it suit my Next-Gen Ranger?

It is listed to fit the Next-Gen T6.2 Ford Ranger 4cyl 2.0L bi-turbo. MPI Automotive does not publish a year range against this listing, so we confirm your exact build off the compliance plate before ordering. RRP is $1,537.73.

Is it road legal?

This is a DPF-back, so it sits behind the diesel particulate filter and leaves that hardware in place. Even so, configuration and noise factor into compliance — confirm the exact build and any state requirements with the workshop before fitting. We do not claim approval on a vehicle we have not inspected.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men fits these Next-Gen Ranger DPF-backs in our Illawarra bays. A twin-tip side exit needs the tips set square in the rear quarter, so we mock up the exit, confirm clearance to the body, and align the run before final clamping. Bring the Ranger in and we will confirm the build.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Will the SSMKFD0280T fit my Ranger?
It is listed to fit the Next-Gen T6.2 Ford Ranger 4cyl 2.0L bi-turbo. Confirm your exact build with the workshop, as no year is published against it.
Does it have a centre muffler?
No. This build deletes the centre muffler for a more open mid-section.
Does it remove the DPF?
No. A DPF-back sits behind the diesel particulate filter and leaves it in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.