SSMKFD0296

Ford Next Gen T6.2 Ranger V6 4in DPF Back Without Centre Muffler

Ford Next Gen T6.2 Ranger V6 4in DPF Back Without Centre Muffler (SSMKFD0296) Fits FORD. Fast.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2388.39 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Next Gen T6.2 Ranger V6 4in DPF Back Without Centre Muffler product image

Part specs

SKU
SSMKFD0296
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Built at 4in, the MPI Automotive SSMKFD0296 is a DPF-back exhaust for the Next-Gen Ford Ranger V6 that runs without a centre muffler — the deletion that sets it apart from a quieter DPF-back, opening the note up behind the cab.

What does a 4in DPF-back change?

A DPF-back replaces everything from the diesel particulate filter outlet rearward, so it starts downstream of the emissions hardware and leaves the DPF in place. The SSMKFD0296 is sized at 4in — a large-bore step for the Ranger's V6 turbo-diesel that reduces back-pressure across the rear half of the system. It deliberately omits the centre muffler, which is the single biggest reason this listing reads differently from a muffler-equipped DPF-back.

What does deleting the centre muffler do?

With no centre muffler in the run, the gas takes a straighter path and the cabin hears more of the engine's natural diesel tone. There's no chambered box damping the mid-section, so expect a fuller, less restrained note than a muffler-equipped build — we describe it by design, not by any decibel figure we don't have.

Does it keep the Ranger road-legal?

This is a DPF-back, so it sits behind the particulate filter and leaves that emissions component where the factory put it. That's the part most owners care about on a modern diesel. Confirm the exact build and any state requirements with the workshop before fitting.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits MPI systems like this across the Illawarra. The SSMKFD0296 is listed to fit the Next-Gen T6.2 Ranger V6; send through your exact build and we'll confirm clearances over the rear axle and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Why is there no centre muffler on the SSMKFD0296?
This version deletes the centre muffler by design — it's the variant for owners wanting a fuller note rather than the most subdued one. A muffler-equipped DPF-back is the quieter alternative.
Does it remove the DPF?
No. As a DPF-back it starts behind the diesel particulate filter and leaves that emissions hardware in place.
Will it fit my Next-Gen Ranger V6?
It's listed to fit the Next-Gen T6.2 Ford Ranger V6. Confirm your exact variant with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.