SSMKFD0297

Ford Next Gen T6.2 Everest V6 3in DPF Back With Centre Muffler With 4in Tip

Ford Next Gen T6.2 Everest V6 3in DPF Back With Centre Muffler With 4in Tip.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $1948.50 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Next Gen T6.2 Everest V6 3in DPF Back With Centre Muffler With 4in Tip product image

Part specs

SKU
SSMKFD0297
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

Built for the V6 Everest and keeping a centre muffler in the run, the MPI Automotive SSMKFD0297 is a 3in DPF-back listed to fit the Next-Gen T6.2 Ford Everest V6. The retained centre muffler makes it the more subdued of the Everest DPF-back builds, finished on a 4in tip.

What's specific to the V6 build?

This SKU is cut for the V6 Everest rather than the four-cylinder, and it keeps the centre muffler in place. That centre muffler is the headline: it gives the system a second stage of chambered silencing, so the note stays refined behind the V6 rather than getting boomy. At 3in from the DPF back, it's sized for the engine while leaving the filter and emissions hardware untouched, and it exits through a 4in tip.

What does a DPF-back change, and what stays?

A DPF-back replaces the exhaust from the diesel particulate filter rearward, so the DPF and everything ahead of it stay in place. On the V6 Everest that frees up the rear section without touching the emissions hardware. Keeping the centre muffler means this build trades a little volume for a quieter cabin — the considered choice for a touring or family V6 Everest.

Is the DPF retained?

Yes. As a DPF-back, the diesel particulate filter and the emissions hardware in front of it remain fitted, keeping the Everest closer to factory emissions behaviour than a filter-delete would. Confirm the exact build and any current state requirements with the workshop before fitting, as setups and rules vary.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits DPF-back systems like this in-house across the Illawarra. It's listed to fit the Next-Gen T6.2 Everest V6; send us your build and we'll confirm clearances, the centre muffler position and the 4in tip alignment before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the SSMKFD0297 quieter than a centre-delete build?
Yes — it keeps the centre muffler, giving a second stage of silencing for a more subdued note. No decibel figure is published.
Does it keep the DPF?
Yes — it's a DPF-back, so the diesel particulate filter and the emissions hardware ahead of it stay in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.