SSMKFD0324

Ford Falcon BA BF Barra V8 Sedan 3in Full System with Centre and Rear Muffler

MPI Automotive Ford Falcon BA BF Barra V8 Sedan 3in Full System with Centre and Rear Muffler.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $5038.83 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Ford Falcon BA BF Barra V8 Sedan 3in Full System with Centre and Rear Muffler product image

Part specs

SKU
SSMKFD0324
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Ford
Stock status
In stock at supplier

A single 3in run rather than a split dual is what characterises the MPI Automotive SSMKFD0324 — a 3in full system listed to fit the BA/BF Ford Falcon V8 sedan. It carries both a centre and a rear muffler, so it stays refined while stepping up the bore.

What does a single 3in full system mean here?

This is a single-pipe 3in run from front to back rather than a twin-pipe dual layout. A 3in bore is the larger-diameter step up from the factory tube, sized around the Falcon V8's output. Running one big pipe is a simpler, often tidier route under the sedan floor, and on the SSMKFD0324 it's paired with two mufflers to keep the note in hand. It's the choice for an owner who wants the bigger bore without the complexity of a full dual.

Why the centre and rear muffler combination?

Two chambered mufflers give the system two stages of silencing — the centre muffler tames mid-system drone, the rear handles the tailpipe. That keeps a 3in single system from getting boomy in the cabin. It's the refined end of the spectrum: a fuller V8 note than stock, but deliberately civil for a daily-driven sedan.

Will it suit my BA/BF Falcon V8 sedan?

It's listed to fit the BA/BF Falcon V8 sedan, with the sedan body setting the routing and clearances. Confirm your exact model and build with the workshop before ordering — these full systems are body-specific and we verify the match rather than trusting feed data alone.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits full systems like this in-house across the Illawarra. We'll confirm hanger points and the centre and rear muffler positions for your BA/BF sedan before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the SSMKFD0324 a dual system?
No — it's a single 3in full system, one larger pipe front to back, with a centre and rear muffler. Confirm the layout suits your build with the workshop.
What size is the pipework?
It's a 3in full system, stepped up from the factory tube and sized around the Falcon V8.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.