SSMKTY0059

Prado KDJ120, KDJ150, 3.0L D4D Engine, 3in Turbo Back, Centre & Rear Muffler With Cat

Prado KDJ120, KDJ150, 3.0L D4D Engine, 3in Turbo Back, Centre & Rear Muffler With Cat.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2393.70 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Prado KDJ120, KDJ150, 3.0L D4D Engine, 3in Turbo Back, Centre & Rear Muffler With Cat product image

Part specs

SKU
SSMKTY0059
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0059 keeps the catalytic converter in place — that's its distinguishing point. It's a 3in turbo-back listed to fit the Toyota Prado KDJ120/KDJ150 3.0L D-4D, retaining the cat and running a centre and rear muffler.

What does keeping the cat change?

On a diesel turbo-back, the catalytic converter is the piece that keeps the factory emissions hardware in the run. The SSMKTY0059 retains it, so unlike a cat-delete version this is the with-cat path — the one that leaves the Prado's emissions equipment where the factory put it. That's the reason to choose this SKU over a no-cat alternative, and it's worth confirming any state requirements with the workshop before fitting.

How is a 3in turbo-back built?

A turbo-back spans the exhaust from the turbo outlet rearward, the full engine-back section rather than a tailpipe swap. The 3in bore is sized for the 3.0L D-4D, and a centre-plus-rear muffler arrangement keeps the note controlled across the length of the system. With the cat retained, gas passes through the factory emissions hardware before reaching the mufflers.

Does it fit the KDJ120 and KDJ150?

It's listed to fit the Toyota Prado KDJ120 and KDJ150 with the 3.0L D-4D engine. Catalogue fitment isn't a promise, so give us your exact chassis and we'll verify the layout and clearances before ordering.

What's involved in fitting it locally?

Oak Flats Muffler Men supplies and fits this in-house in the Illawarra. We'll check the cat location, hanger points and muffler positioning on your Prado, confirm the build and book the bay once the fitment is confirmed.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKTY0059 keep the catalytic converter?
Yes — this is the with-cat turbo-back, so the factory catalytic converter stays in the run.
Will it fit my 3.0L D-4D Prado?
It's listed to fit the Prado KDJ120 and KDJ150 with the 3.0L D-4D. Confirm your exact variant with the workshop first.
How is the noise managed?
It uses a centre and a rear muffler, so the note is silenced at two points along the system.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.