SSMKTY0101

Toyota Landcruiser VDJ200 DPF 2.5in With Cat Muffler C&R, Dump Tip

Toyota Landcruiser VDJ200 DPF 2.5in With Cat Muffler C&R, Dump Tip.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $4101.39 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Landcruiser VDJ200 DPF 2.5in With Cat Muffler C&R, Dump Tip product image

Part specs

SKU
SSMKTY0101
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0101 is a 2.5in DPF-back with a muffler, the catalytic converter retained and both a centre and rear dump tip, listed to fit the Toyota Landcruiser VDJ200 DPF. The cat-retained build with twin dump-tip exits is the defining mix — compliance hardware in place, extra exit routing underneath.

What sets this cat-retained, twin dump-tip build apart?

This 2.5in DPF-back keeps the cat and exits through both a centre and a rear dump tip. The dual dump routing is the distinguishing feature against the rear-only cat-retained version — it changes where the gas leaves the underbody, which some 200-Series owners prefer for clearance or crossings, while the retained cat keeps the factory emissions hardware in place.

What does the DPF-back run cover?

This is a DPF-back system at 2.5in, picking up after the diesel particulate filter and carrying through a muffler to the centre and rear dump tips. The cat stays in the system, and the muffler keeps the note from getting harsh on the heavy 200-Series wagon.

Is it road legal?

Because the SSMKTY0101 retains the catalytic converter, the cat the wagon left the factory with remains in the system. The DPF and the rest of the compliance picture are build-specific, so confirm the exact specification and any state requirements with the workshop before fitting.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits DPF-back systems like this in-house across the Illawarra. We check the 2.5in routing past the DPF, set the muffler, both dump-tip exits and hangers, and seal the joins. RRP is $4,101.39; bring the 200 in and we'll confirm the build and exit positions before booking.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKTY0101 keep the cat?
Yes — it's a with-cat system, so the factory catalytic converter stays in place.
How does it exit?
It runs a centre and a rear dump tip, so the gas leaves at two underbody points rather than a single rear exit.
What bore is it?
It's a 2.5in DPF-back as published by the supplier, suited to a near-stock 200-Series.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.