SSMKTY0102

Toyota Landcruiser VDJ200 DPF 2.5in With Cat, Muffler Rear, Dump Tip

MPI Automotive Toyota Landcruiser VDJ200 DPF 2.5in With Cat, Muffler Rear, Dump Tip.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3763.66 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Landcruiser VDJ200 DPF 2.5in With Cat, Muffler Rear, Dump Tip product image

Part specs

SKU
SSMKTY0102
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0102 is a 2.5in DPF-back with a muffler, the catalytic converter retained and a rear dump tip, listed to fit the Toyota Landcruiser VDJ200 DPF. Keeping the cat on a 2.5in single-pipe build is the defining point — the most compliance-friendly, modest-bore option in this 200-Series range.

Why the cat-retained 2.5in build?

This DPF-back keeps the catalytic converter and runs at 2.5in, so the factory emissions hardware stays in place and the bore stays modest. That combination separates it from the cat-delete versions — it's the choice for a near-stock 200-Series wanting a single-pipe DPF-back with the cat retained and the note kept quiet through a muffler.

What does the DPF-back run cover?

This is a DPF-back system at 2.5in, picking up after the diesel particulate filter and carrying through a muffler to a rear dump tip. Keeping the cat means the emissions hardware the wagon left the factory with stays in the system, and the muffler keeps the note settled on the heavy 200-Series.

Is it road legal?

Because the SSMKTY0102 retains the catalytic converter, the cat the wagon carries from the factory remains in the system. The DPF and the rest of the compliance picture are build-specific, so confirm the exact specification and any state requirements with the workshop before fitting.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits DPF-back systems like this in-house across the Illawarra. We check the 2.5in routing past the DPF, set the muffler, rear dump tip and hangers, and seal the joins. RRP is $3,763.66; bring the 200 in and we'll confirm the build and exit position before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKTY0102 keep the cat?
Yes — it's a with-cat system, so the factory catalytic converter stays in place.
What bore is it?
It's a 2.5in DPF-back as published by the supplier, suited to a near-stock 200-Series.
Where does it exit?
It finishes with a rear dump tip, which exits before the rear bumper rather than through a finished tailpipe.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.