SSMKTY0108

Toyota Landcruiser VDJ200 DPF 3in Dual With Cat & Muffler 4in Tailpipe

Toyota Landcruiser VDJ200 DPF 3in Dual With Cat & Muffler 4in Tailpipe.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $4884.53 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Landcruiser VDJ200 DPF 3in Dual With Cat & Muffler 4in Tailpipe product image

Part specs

SKU
SSMKTY0108
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0108 finishes in a 4in tailpipe: a dual 3in DPF-back system for the Toyota Landcruiser VDJ200, run with the catalytic converter and a muffler. The larger 4in tailpipe is the styling-and-flow flourish over the dual 3in run, with the cat retained for a road build.

Why the 4in tailpipe?

The standout here is the 4in tailpipe the system exits through, a step up in diameter from the dual 3in pipework feeding it. That gives the VDJ200 a fuller rear-end presence and an unrestricted final exit, while the twin 3in run upstream sets the actual flow for the V8 turbo-diesel. It is the difference that sets this build apart from a same-diameter exit.

Why keep the cat, and what does the muffler add?

This is the with-cat build, so the catalytic converter stays where the factory fitted it, the key emissions point for road compliance on a diesel wagon. The muffler keeps the note settled rather than raw, suited to a vehicle that does highway distance. Confirm the exact build and any state requirements with the workshop before fitting.

Will it suit my VDJ200 Landcruiser?

It is listed to fit the Toyota Landcruiser VDJ200 with the DPF. Build varies, so send yours through and we will confirm the 4in tailpipe clearance against your rear bar before ordering, as listing data is not a guarantee.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this MPI DPF-back in-house across the Illawarra. We check the cat and DPF connection, route the dual 3in run and the 4in tailpipe, and verify hangers on your VDJ200 before booking. RRP is $4884.53.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

What size is the tailpipe on the SSMKTY0108?
It finishes in a 4in tailpipe, stepping up from the dual 3in pipework that feeds it.
Does it keep the cat?
Yes. It is the with-cat build, retaining the factory converter. Confirm any state requirements with the workshop.
Will it fit my VDJ200?
It is listed to fit the Toyota Landcruiser VDJ200 DPF; confirm your exact build with the workshop first.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.