SSMKTY0130

Toyota Landcruiser VDJ79 V8 Ute Dual 3in With Cat & Hotdog DPF

Toyota Landcruiser VDJ79 V8 Ute Dual 3in With Cat & Hotdog DPF (SKU: SSMKTY0130) Engineered. Quality guaranteed.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $3693.42 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Toyota Landcruiser VDJ79 V8 Ute Dual 3in With Cat & Hotdog DPF product image

Part specs

SKU
SSMKTY0130
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0130 is a dual 3in DPF-back system for the Toyota Landcruiser VDJ79 V8 ute, run with the catalytic converter and a hotdog. The twin 3in path is the big-flow option for the 4.5L V8 diesel, keeping the cat in place on a road-going build.

Why a dual 3in DPF-back?

Running two 3in pipes from the DPF back gives the VDJ79 V8 ute a generous total flow area, which is what a torquey turbo-diesel V8 can use once the factory restriction is gone. The dual layout splits the gas across two paths to the rear, and at 3in each pipe is sized for the engine rather than over- or under-doing the bore.

Why keep the cat, and what does the hotdog add?

This is the with-cat build, so the catalytic converter stays where the factory put it, the key emissions point for road compliance on a diesel ute. The hotdog is a compact straight-through resonator that targets cruise drone without choking the dual run. Confirm the exact build and any state requirements with the workshop before fitting.

Will it suit my VDJ79 V8 ute?

It is listed to fit the Toyota Landcruiser VDJ79 V8 in ute body. Cab and build vary, so send yours through and we will confirm clearances for the dual run before ordering; listing data is not a guarantee.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this MPI DPF-back in-house across the Illawarra. We check the cat and DPF connection, route both 3in pipes and the hotdog, and verify hangers on your VDJ79 before booking. RRP is $3693.42.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKTY0130 keep the cat?
Yes. It is the with-cat build, retaining the factory converter. Confirm any state requirements with the workshop.
Why is it a dual 3in?
Twin 3in pipes give the VDJ79 V8 a generous total flow area for the diesel V8 once the factory restriction is gone.
What does the hotdog do?
It is a straight-through resonator that targets cruise drone without choking the dual run.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.