SSMKTY0191

Landcruiser VDJ79 V8 4.5L TD, Ute 2016 To Current, 4in Single DPF Back Without Muffler

Landcruiser VDJ79 V8 4.5L TD, Ute 2016 To Current, 4in Single DPF Back Without Muffler (SSMKTY0191).

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2298.99 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Landcruiser VDJ79 V8 4.5L TD, Ute 2016 To Current, 4in Single DPF Back Without Muffler product image

Part specs

SKU
SSMKTY0191
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0191 is a 4in single DPF-back for the VDJ79 Landcruiser ute (4.5L V8 turbo-diesel, 2016 to current), run without a muffler — being a DPF-back, it starts behind the particulate filter, which is the key difference from the full DPF systems in this family.

Why a DPF-back rather than a full system?

The SSMKTY0191's defining attribute is its starting point: a DPF-back begins behind the diesel particulate filter, so it replaces only the rear section and leaves the DPF and forward hardware in place. That's a shorter, different system from the full 4in DPF builds for the same VDJ79, and it shows in the lower RRP for this part.

What does the 4in single, no-muffler layout give?

At 4in single and run without a muffler, this is a large-bore, open rear section for the 4.5L V8 turbo-diesel ute. The muffler delete makes the note fuller than a muffled DPF-back — described by design, not by any decibel reading.

Is it road legal?

As a DPF-back it leaves the diesel particulate filter in place, which is the component owners most want retained on a modern diesel. Confirm the exact build and any state requirements with the workshop before fitting.

Will it suit my VDJ79?

It's listed to fit the 2016-to-current VDJ79 Landcruiser 4.5L V8 turbo-diesel ute. Oak Flats Muffler Men supplies and fits these across the Illawarra — send your build and we'll confirm clearances along the ute chassis before booking. At the bay we check the DPF join, the hanger positions and the run of the 4in single pipe past the rear axle. The SSMKTY0191 is supplied by MPI Automotive and may be ordered in, so we'll confirm stock and timing when you book.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the SSMKTY0191 a DPF-back?
Yes — it starts behind the diesel particulate filter and replaces only the rear section, unlike a full DPF system.
Does it have a muffler?
No — it runs without a muffler for a fuller, more open note.
Does it remove the DPF?
No. As a DPF-back the particulate filter stays in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.