SSMKTY0307

Landcruiser 300 Series V6, 3in DPF Back Without Muffler, 4in Black Tip

Landcruiser 300 Series V6, 3in DPF Back Without Muffler, 4in Black Tip (SSMKTY0307) Fits TOYOTA. Fast.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2086.30 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Landcruiser 300 Series V6, 3in DPF Back Without Muffler, 4in Black Tip product image

Part specs

SKU
SSMKTY0307
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0307 is a 3in DPF-back for the V6 Landcruiser 300 Series, run without a muffler and finished with a 4in black tip — being a DPF-back rather than a turbo-back is what sets it apart, keeping the particulate filter in place.

Why a DPF-back rather than a turbo-back?

This SKU's distinguishing attribute is where it starts: a DPF-back begins behind the diesel particulate filter, so it replaces only the rear portion and leaves the DPF and upstream emissions hardware untouched. That's a meaningfully different system from a full turbo-back on the same 300 Series — a shorter span and a different compliance picture.

What do the muffler delete and black tip add?

The SSMKTY0307 runs without a muffler for a fuller, more open note across the 3in rear section, and finishes through a 4in black tip for a darker, understated tailpipe. Together they're the configuration and styling that mark this listing — described by design, not by any sound figure.

Is it road legal?

As a DPF-back it leaves the diesel particulate filter in place, which is the component owners most want retained on a modern diesel. Confirm the exact build and any state requirements with the workshop before fitting.

Will it suit my 300 Series?

It's listed to fit the V6 Toyota Landcruiser 300 Series. Oak Flats Muffler Men supplies and fits these across the Illawarra — send your build and we'll confirm fitment and tip finish before booking. At the bay we check the DPF join, the hanger positions and the 4in black tip alignment at the rear bar. The SSMKTY0307 is supplied by MPI Automotive and may be ordered in, so we'll confirm stock and timing when you book.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the SSMKTY0307 a DPF-back or turbo-back?
A DPF-back — it starts behind the diesel particulate filter and leaves the DPF in place, unlike a full turbo-back.
What tip and muffler config does it use?
A 4in black tip, and it runs without a muffler for a more open note.
Does it remove the DPF?
No. As a DPF-back the particulate filter stays in place.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.