SSMKTY0343

Landcruiser VDJ200, 3in DPF Back With Muffler & 4in Tailpipe

MPI Automotive Landcruiser VDJ200, 3in DPF Back With Muffler & 4in Tailpipe.

BrandMantaMPI Automotive

Category: Mufflers and resonators

RRP $2513.20 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Landcruiser VDJ200, 3in DPF Back With Muffler & 4in Tailpipe product image

Part specs

SKU
SSMKTY0343
Supplier
MPI Automotive
Category
Mufflers and resonators
Vehicle fitment
Toyota
Stock status
In stock at supplier

The MPI Automotive SSMKTY0343 is a 3in DPF-back exhaust for the Toyota Landcruiser VDJ200, running a muffler and finishing on a 4in tailpipe. The DPF-back layout is the key point: it replaces the system from behind the diesel particulate filter rearward, so the factory DPF stays in place and only the section after it is upgraded.

What does a DPF-back system change?

A DPF-back run starts behind the diesel particulate filter and replaces everything from there to the tip — a shorter span than a turbo-back. On the VDJ200 this means the factory DPF and the emissions hardware ahead of it are left untouched, and the 3in pipework, muffler and 4in tailpipe handle flow and sound from the filter back. It is the rear-section upgrade rather than a full engine-back change.

Muffler and 4in tailpipe — what's the character?

The system runs a muffler, so it leans toward a measured note rather than a hard, raw one — the muffler quietens through chambering and absorption. It finishes on a 4in tailpipe for the visible exit. The combination suits a 200 Series owner wanting a freer rear section while keeping the cabin civil on long trips.

Is it road legal?

Because the SSMKTY0343 keeps the factory diesel particulate filter in place, it leaves the emissions hardware that matters for diesel road compliance untouched. Confirm your exact VDJ200 build and any NSW requirements with the workshop before fitting.

How do we fit it at the workshop?

Oak Flats Muffler Men supplies and fits VDJ200 DPF-back systems across the Illawarra. The SSMKTY0343 is listed to fit the Landcruiser VDJ200; bring us your build and we will confirm the DPF-back join, clearances and tailpipe routing before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the SSMKTY0343 remove the DPF?
No. It is a DPF-back system, so it replaces the section behind the diesel particulate filter and leaves the factory DPF in place.
Will it fit my Landcruiser 200 Series?
It is listed to fit the Toyota Landcruiser VDJ200. Confirm your exact variant with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.