EM-VE07-JPL-3

Redback Stainless 3" J pipe muffler delete Left for Holden Commodore V

Redback Redback Stainless 3" J pipe muffler delete Left.

BrandRedbackSWD

Category: Mufflers and resonators

RRP $198.99 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Stainless 3" J pipe muffler delete Left for Holden Commodore V product image

Part specs

Tube Size
076mm (3")
Material Type
409 Stainless Steel
Fitting Time [min.]
60

EM-VE07-JPL-3 is a left-hand 304-stainless J-pipe muffler delete listed for the Holden Commodore. Supplied by Redback, it's the left-side delete pipe for this listing's spec — a stainless J-shaped section that takes the place of the rear muffler so the run flows straight through.

How does a muffler-delete J-pipe work?

In place of a rear silencer, this part is a J-shaped length of pipe that follows the muffler's old route and lets gas pass straight through. There's no chambered box to soften the sound, so the exhaust note comes through louder and harder. It's the left-side unit, handed to match the routing on that side of a dual rear setup and to mate where the original left muffler was mounted.

What does 304 stainless bring?

This J-pipe is made from 304 stainless — a higher grade than the 409 used for a lot of exhaust work, with strong corrosion resistance. On a deleted section sitting exposed at the back of the car, that resistance matters: the stainless resists the rust that eventually eats through mild-steel pipe. It makes the left-side delete a durable, long-life section rather than a part you'll be chasing rust on.

Will it suit my Commodore and is it loud?

It's listed to fit the left-hand side of the Holden Commodore for this spec. Because it deletes the muffler and runs straight through, it's distinctly louder than a system that keeps the rear box — make sure the finished exhaust suits your noise and registration needs. Confirm your exact model, side and the rest of your pipework with the workshop before ordering.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men supplies and fits this J-pipe in-house across the Illawarra. We remove the left-side rear muffler, fit the stainless J-pipe in its place, and check alignment, clearance and hangers so it sits clean. Bring your Commodore in and we'll confirm the side and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this a muffler or a delete pipe?
A delete pipe — it replaces the rear muffler with a straight J-pipe, so there's no silencer in that position and the note is louder.
Which side does it fit?
The left-hand side of the Commodore. Confirm your exact model and spec with Oak Flats Muffler Men before ordering.
What material is it?
304 stainless — corrosion-resistant and suited to an exposed rear section.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.