K-RPM16022

Redback Dual 3" Engine back Exhaust with Muffler Delete for Holden Commodore VE & VF

Redback Redback Dual 3" Engine back Exhaust with Muffler Delete.

BrandRedbackRedback Exhausts

Category: Mufflers and resonators

RRP $4263.14 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Dual 3" Engine back Exhaust with Muffler Delete for Holden Commodore VE & VF Sedan / Wagon product image

Part specs

SKU
K-RPM16022
Supplier
Redback Exhausts
Category
Mufflers and resonators
Vehicle fitment
holden
Stock status
Order in

Configured as a muffler-delete, the Redback K-RPM16022 is a dual 3in engine-back exhaust listed to fit the Holden Commodore VE and VF Sedan and Wagon. Deleting the rear mufflers from a twin 3in engine-back is the loud, free-flowing end of the range.

What does the muffler delete deliver?

Pulling the rear mufflers out of a dual 3in engine-back leaves the gas with the least restriction Redback offers for this car, so the note is loud and hard. There's no rear box to soak up volume — what you hear is close to open dual 3in pipework exiting the back of the VE/VF.

What does engine-back mean on the VE/VF?

Engine-back is the longest run in the catalogue: it replaces the system from the engine all the way to the tailpipe, in twin 3in here. That's a much bigger job than a cat-back and is reflected in the price. It suits an owner building the whole exhaust side in one hit rather than upgrading a section at a time.

Is a muffler delete road legal in NSW?

This deletes the rear mufflers, not the catalytic converters, so the emissions hardware isn't the issue — noise is. An engine-back with the mufflers removed runs loud, and NSW stationary and drive-by noise limits apply for registration. Confirm the build and noise requirements with the workshop before fitting.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men supplies and fits the K-RPM16022 in-house. A twin 3in engine-back is a full-length job on the hoist — we align both banks from the engine back, set every hanger and check clearance under the sedan or wagon floor and over the rear axle.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the K-RPM16022 remove the catalytic converters?
No. It deletes the rear mufflers only. The catalytic converters are not part of this delete.
Will it fit both the sedan and the wagon?
It's listed for the VE and VF Sedan and Wagon. Confirm your exact body and build with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.