EM-VE09-JPR-3

Redback Stainless 3" J pipe muffler delete Right for Holden Commodore

Redback Redback Stainless 3" J pipe muffler delete Right.

BrandRedbackSWD

Category: Mufflers and resonators

RRP $198.99 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Stainless 3" J pipe muffler delete Right for Holden Commodore product image

Part specs

Tube Size
076mm (3")
Material Type
409 Stainless Steel

EM-VE09-JPR-3 is a right-hand 304-stainless J-pipe that deletes the muffler on the Holden Commodore. Supplied by Redback, it replaces a rear muffler with a J-shaped pipe on the right side — the louder, free-flowing path in a durable stainless body.

What is a J-pipe muffler delete?

A J-pipe muffler delete swaps a rear muffler for a J-shaped length of pipe that follows the same route the box used to take, so gas runs straight through instead of passing through a silencer. With the absorptive muffler gone the note is louder and harder. As a handed right-side piece it mirrors the routing of that side of a dual rear setup, mating where the original right muffler sat.

Why 304 stainless?

304 is a higher-grade stainless than the 409 often used for exhaust, with strong corrosion resistance — well suited to a deleted section that's exposed at the rear of the car. The stainless body resists the rust that eats mild-steel pipework over time, so the delete pipe holds up rather than corroding through. It's the durable choice for a straight-through right-side section.

Will it suit my Commodore and is it loud?

It's listed to fit the right-hand side of the Holden Commodore as a J-pipe muffler delete. Running straight through, it's noticeably louder than a system with the rear muffler in place — check the finished exhaust suits your noise and registration needs. Confirm your exact model, side and pipework with the workshop before ordering.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men supplies and fits this J-pipe in-house across the Illawarra. We remove the right-side rear muffler, fit the stainless J-pipe in its place, and check alignment, clearance and hangers so it sits clean. Bring your Commodore in and we'll confirm the side and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the EM-VE09-JPR-3 make the car louder?
Yes — it deletes the rear muffler and runs a straight J-pipe, so the note is louder and harder than with the muffler in place.
What's it made from?
304 stainless — a higher-grade, corrosion-resistant stainless, well suited to an exposed rear section.
Which side is it?
The right-hand side. It's a handed J-pipe, so it has to match the right side of your Commodore.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.