ford-falcon-ba-bf-sedan-xr6-2-1-2-catback-kit-inc-hotdog-tailpipe

FORD FALCON BA - BF SEDAN XR6 2 1/2" CATBACK KIT INC HOTDOG & TAILPIPE

FORD FALCON BA - BF SEDAN XR6 2 1/2" CATBACK KIT INC HOTDOG & TAILPIPE for Performance Car - Ford.

DistributorExhaust Systems Australia

Category: Mufflers and resonators

RRP $275.00 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
FORD FALCON BA - BF SEDAN XR6 2 1/2" CATBACK KIT INC HOTDOG & TAILPIPE product image

Part specs

SKU
ford-falcon-ba-bf-sedan-xr6-2-1-2-catback-kit-inc-hotdog-tailpipe
Supplier
Exhaust Systems Australia
Category
Mufflers and resonators
Stock status
Confirmed on order

A hotdog resonator into a single tailpipe is the layout behind the FORD-FALCON-BA-BF-SEDAN-XR6-2-1-2-CATBACK-KIT-INC-HOTDOG-TAILPIPE, a 2in cat-back kit listed to fit the Ford Falcon BA-BF XR6 sedan.

Why a hotdog and a single tailpipe?

Supplied by Exhaust Systems Australia, the hotdog here is a compact straight-through resonator, so it trims drone and keeps flow up rather than chambering the gas down like a muffler. Feeding a single tailpipe, it gives the BA-BF XR6 a freer, slightly louder exhale than the factory rear without going to a dual-exit build. It is the flow-minded single-exit option in the BA-BF range.

What does the cat-back kit replace?

As a cat-back kit it replaces the system from behind the catalytic converter rearward, leaving the factory cat in place. At 2in it suits the XR6, and the kit brings the hotdog and the single tailpipe together as a matched rear section.

Will it suit my BA or BF XR6?

It is listed to fit the Ford Falcon BA-BF sedan in XR6 trim. Rear-bar exits and the BA-to-BF tail vary, so confirm your exact build with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men fits these XR6 cat-back kits in the Illawarra. We set the hotdog in the run, line the tailpipe square to the rear bar, and check clearance over the beam before you collect the car. It is listed at $275, and the supplier does not publish the construction material, so we confirm the hotdog and tailpipe against your XR6 on arrival before fitting.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this a single-exit kit?
Yes. It runs a hotdog resonator into a single tailpipe, the flow-minded single-exit option for the BA-BF XR6 sedan.
Is the hotdog a muffler?
No, it is a compact straight-through resonator. It trims drone while keeping flow up, rather than chambering the gas like a muffler.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.