ford-falcon-ea-au-sedan-3-rear-with-muffler

FORD FALCON EA-AU SEDAN 3" REAR WITH MUFFLER

Exhaust Systems Australia FORD FALCON EA-AU SEDAN 3" REAR WITH MUFFLER.

DistributorExhaust Systems Australia

Category: Mufflers and resonators

RRP $305.00 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
FORD FALCON EA-AU SEDAN 3"  REAR WITH MUFFLER product image

Part specs

SKU
ford-falcon-ea-au-sedan-3-rear-with-muffler
Supplier
Exhaust Systems Australia
Category
Mufflers and resonators
Stock status
Confirmed on order

Built at a 3in bore, the Exhaust Systems Australia FORD-FALCON-EA-AU-SEDAN-3-REAR-WITH-MUFFLER is the rear section, complete with muffler, for the EA–AU Falcon sedan — the big-bore tailpipe end of the system rather than a centre or front part.

What does the 3in rear-with-muffler cover?

This is the rear section of the exhaust, supplied with its muffler, built on a 3in bore. It's the part that sits over the back axle and sets the final note as the gases exit, so swapping it changes the tailpipe character while leaving the front and centre of the run in place. At 3in it's sized for a Falcon six that's been opened up or built for freer breathing rather than the standard pipe.

What does the muffler do at the rear?

The rear muffler quietens by absorbing and reflecting sound inside its body, settling the note before it leaves the tailpipe. Because this section spans the whole EA-to-AU sedan range, the routing is shaped for the long-running Falcon sedan floor. We can't quote a sound level — there's no dB data — so the honest measure is to hear a comparable car fitted with the same part.

Will it suit my EA–AU Falcon sedan?

It's listed to fit the Ford Falcon EA through AU sedan, built on a 3in bore as a rear-with-muffler section. The Falcon ran many series across that span, so confirm your exact build with the workshop before ordering.

How do we fit it in the Illawarra?

Oak Flats Muffler Men supplies and fits this rear section in-house across the Illawarra. We mate it to the section ahead, hang the muffler clear of the floor and set the tailpipe square at the rear. Bring the Falcon in and we'll confirm fitment and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is this the whole exhaust or just the rear?
Just the rear section, supplied with its muffler — the 3in tailpipe end, not the front or centre.
What bore is it?
3in — sized for a Falcon six built for freer breathing rather than the standard pipe.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.